Publications
Sort:
Open Access Issue
Optimized design of stiffened panels considering the twist angle error of stringers
Journal of National University of Defense Technology 2025, 47(6): 157-167
Published: 01 December 2025
Abstract PDF (6.1 MB) Collect
Downloads:2
Objective

The structural design in the aerospace field, while pursuing high load-carrying capacity and lightweight, often leads to a significant increase in the sensitivity to structural defects and processing errors. In practical engineering, the twist angle error of stringers is one of the main processing errors of thin-walled stiffened structures. Due to the relatively few related studies, it is urgent to carry out the optimization design of stiffened panels considering the twist angle error of stringers.

Methods

The finite element model of post-buckling instability of stiffened panels under axial compression was established. The crushing failure mechanism and buckling instability mode of stiffened panels were explored, and the sensitivity of the load-carrying capacity to the twist angle error on stringers and the distribution position of the torsional stringer was analyzed. On this basis, a parallel sequential approximate optimization method based on the surrogate model was proposed by using the parallel sequential sampling strategy. This method realized parallel sequential sampling considering both exploration and development strategies, and achieved high-efficiency optimization in the complex design domain. Furthermore, based on this method, the lightweight design of a stiffened panel was carried out under the influence of twist angle error of stringers.

Results

The local instability waves of the skin between the frames and stringers caused the coupling deformation of the stringers and the skin, and the induced bending and torsion coupling warping instability of the stringers was the main reason for the overall crushing failure of the stiffened panel. For the stiffened panels studied, the torsion stringer is distributed in the middle, and the twist angle is maintained within 10°, which can effectively control the reduction factor of the bearing capacity of the stiffened panel below 1%. At the same time, reducing the width-to-thickness ratio of the flange and the height-to-thickness ratio of the web of the torsional stringer will effectively lower the sensitivity of the structural load-carrying capacity to the twist angle error of the stringer. In terms of optimization, compared with the optimization design scheme without error influence, the optimization scheme considering the twist angle error of stringers has lower sensitivity to the twist angle error when the weight is reduced by more than 32%.

Conclusions

The established post-buckling instability finite element model can effectively reveal the crushing failure mechanism of the stiffened panel under the initial twist angle error of stringers. Then, the structural forms with lower error sensitivity are given, which provide theoretical support and technical reference for the structural examination and evaluation of the existing twist angle error of stringers. In addition, the proposed parallel sequential approximate optimization method is effective for structural optimization design, considering and not considering the twist angle error of stringers, and can efficiently search for the optimal solution in the high-dimensional complex design domain. Finally, the optimized structure of stiffened panels considering the twist angle error of stringers has a higher load-carrying capacity and robustness, which has important engineering application value.

Open Access Issue
Analysis of the influence mechanism of preload variation on axial connection stiffness of clamp band joint
Journal of National University of Defense Technology 2025, 47(1): 113-125
Published: 28 February 2025
Abstract PDF (6.8 MB) Collect
Downloads:18

To accurately calculate the nonlinear bearing capacity of the CBJ (clamp band joint), through the mechanics behavior analysis of each component in the CBJ, a method for calculating the axial connection stiffness of the CBJ considering the change of preload was proposed. A fine finite element model was established considering the nonlinearity of the structure, and the accuracy of the finite element model was verified by axial tensile stiffness experiment. Combined with the finite element model, the theoretical calculation of the device connection stiffness was modified. Based on the established finite element and computational theoretical model, the influence mechanism of the distribution and variation of the belt tension and the initial belt preload on the device strength and connection stiffness was revealed. The results show that the stiffness calculation model can accurately calculate the axial connection stiffness of the device and predict the failure load of the connection, which has important engineering application value.

Total 2