A manufacturing method is proposed for carbon based composite double polymer compliant electrode. The stiffness of this compliant electrode is changed by adjusting the mass fraction of carbon black and the ratios between Ecoflex20 and RT625. Tensile machine is used to test its ductility and hardness. The conductivity is measured through the source table. Finally, it is printed on the dielectric elastomers (DE) film, and the high-voltage amplifier is used for dielectric elastomers actuators (DEAs) dynamics testing. The results show that the compliant electrode has high tensile properties (>200%), low stiffness (<300 kPa) and well conductivity (0.0493 S/cm). It is proved that the DEAs displacement output is up to 1.189 mm by this compliant electrode under dynamic response, which is 1.64 times and 1.32 times of the same type. Moreover, this formula extends the curing time of the original compliant electrode ink. It can provide a reference for the production of compliant electrode and DEAs in the future.
- Article type
- Year
Open Access
Issue
Open Access
Issue
As an important handling tool in the modern intelligent warehousing and logistics industry, omnidirectional automated guided vehicles (AGVs) have greatly improved the efficiency of warehousing and handling operations. However, the existing omnidirectional AGVs have problems such as insufficient bearing capacity of drive structure, poor path tracking accuracy, and poor correction effect. A new type of omnidirectional AGV with two-wheel differential full steering drive mechanism is designed, and a path tracking control strategy using fuzzy neural network PID (FNN-PID) control is proposed to improve the driving performance and path tracking effect of the omnidirectional AGV. Firstly, the new differential full steering drive structure is designed, and its kinematics model is established, the new drive structure has better load-bearing performance. In addition, according to the established kinematics model, the relationship between speed and rotation angle in four different motion modes is analyzed. Finally, the FNN-PID control strategy is used to track and correct the omnidirectional AGV path, and the conjugate gradient (i.e., FR) method is used to learn and train neural network weights, which can improve the response performance of the control system. The proposed control strategy is compared with the traditional PID control strategy through simulation and semicircular path tracking experiments. The simulation and experimental results show that the proposed control strategy can quickly eliminate the deviation in 2 s. The distance deviation is within 1 cm, and the heading deviation is about 1° in the stable tracking stage. The new full steering drive structure has better drive performance and the FNN-PID control strategy using the FR method to learn and train can more effectively track and control the path. The new structure and control method have a certain significance for the precise handling of omnidirectional AGVs.
Open Access
Issue
In complex industrial scenes, it is difficult to acquire high-precision non-cooperative target pose under monocular visual servo control. This paper presents a new method of target extraction and high-precision edge fitting for the wheel of the sintering trolley in steel production, which fuses multiple target extraction algorithms adapting to the working environment of the target. Firstly, based on obvious difference between the pixels of the target image and the non-target image in the gray histogram, these pixels were classified and then segmented in intraclass, removing interference factors and remaining the target image. Then, multiple segmentation results were merged and a final target image was obtained after small connected regions were eliminated. In the edge fitting stage, the edge fitting method with best-circumscribed rectangle was proposed to accurately fit the circular target edge. Finally, PnP algorithm was adopted for pose measurement of the target. The experimental results showed that the average estimation error of pose angle γ with respect to the z-axis rotation was 0.2346°, the average measurement error of pose angle α with respect to the x-axis rotation was 0.1703°, and the average measurement error of pose angle β with respect to the y-axis rotation was 0.2275°. The proposed method has practical application value.
京公网安备11010802044758号