AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (5.3 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Fabrication and stiffness optimization of carbon-based composite double polymer compliant electrode

Xiaojun WU( ), Binhua WEN, Xin TONG, Ying ZHANG
School of Mechanical and Electrical Engineering, Xi’an University of Architecture and Technology, Xi’an 710055, China
Show Author Information

Abstract

A manufacturing method is proposed for carbon based composite double polymer compliant electrode. The stiffness of this compliant electrode is changed by adjusting the mass fraction of carbon black and the ratios between Ecoflex20 and RT625. Tensile machine is used to test its ductility and hardness. The conductivity is measured through the source table. Finally, it is printed on the dielectric elastomers (DE) film, and the high-voltage amplifier is used for dielectric elastomers actuators (DEAs) dynamics testing. The results show that the compliant electrode has high tensile properties (>200%), low stiffness (<300 kPa) and well conductivity (0.0493 S/cm). It is proved that the DEAs displacement output is up to 1.189 mm by this compliant electrode under dynamic response, which is 1.64 times and 1.32 times of the same type. Moreover, this formula extends the curing time of the original compliant electrode ink. It can provide a reference for the production of compliant electrode and DEAs in the future.

References

【1】
【1】
 
 
Journal of Measurement Science and Instrumentation
Pages 471-479

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
WU X, WEN B, TONG X, et al. Fabrication and stiffness optimization of carbon-based composite double polymer compliant electrode. Journal of Measurement Science and Instrumentation, 2022, 13(4): 471-479. https://doi.org/10.62756/jmsi.1674-8042.2022050

626

Views

36

Downloads

0

Crossref

0

CSCD

Received: 21 December 2020
Published: 01 December 2022
© The Author(s) 2022.

The articles published in this open access journal are distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits use, distribution and reproduction in any medium, provided the original work is properly cited.