Sort:
Open Access Research Article Issue
The effect of cell aspect ratio on flow and heat transfer characteristics of anisotropic Kelvin foam
Acta Aerodynamica Sinica 2024, 42(1): 55-66
Published: 17 August 2023
Abstract PDF (3.5 MB) Collect
Downloads:6

High-porosity foam materials are widely used in aircraft thermal management systems due to their light weight and large surface area. The optimization of the geometric parameters in pore scale is crucial for effectively improving the overall heat transfer performance and reducing the structural weight. This paper focuses on anisotropic Kelvin foam structures and uses a hybrid lattice Boltzmann method and multi-GPU acceleration technology to perform conjugate heat transfer numerical simulations that considers both foam skeleton conduction and forced convection heat transfer in the pores on the pore scale. Different cell aspect ratios (H/D = 0.5, 0.75, 1.0, 1.5, 2.0) were selected with various Reynolds numbers (Re = 10, 100, 1000) to study the effect of cell aspect ratio on flow and heat transfer characteristics. The results show that under different Re conditions, as the H/D of the anisotropic Kelvin foam decreases, the flow resistance and Nusselt number inside the foam increase. As the Reynolds number increases, the effect of convective heat transfer becomes stronger, and the influence of H/D becomes more significant. In addition, compared with flow resistance, the structural heat transfer performance changes more rapidly with H/D, and therefore, the comprehensive heat transfer factor is inversely proportional to H/D, which means reducing the H/D of Kelvin foams can effectively improve the overall heat transfer performance of foam structure.

Open Access Research Article Issue
Numerical study of high performance on the influence of angle of attack on aerodynamic performance of wing flapping
Acta Aerodynamica Sinica 2022, 40(5): 50-60
Published: 17 August 2021
Abstract PDF (2.9 MB) Collect
Downloads:7

In order to design a more efficient and highly maneuverable flapping-wing aircraft, it is necessary to conduct meticulous aerodynamics research on the flapping-wing motion mechanism. The angle of attack is a key factor affecting the aerodynamic performance of a flapping-wing motion. Based on the Lattice Boltzmann method and the Level-Set moving boundary recognition method with the GPU acceleration, this work carries out the aerodynamic performance of flapping-wing with the angle of attack ( θ) from 0° to 60°. The results show that with increasing of θ, the lift-to-drag ratio of the flapping-wing increases and then decreases. When θ=10∘, flapping-wing exhibits the best aerodynamic performance. In the range of θ=0∘∼40∘, with increasing of θ, the pressure difference between the upper and lower wing surfaces at the tip of the flapping-wing is greater than that at the root and middle of the wing, which provide greater lift force at the wing tip. As the θ increasing, the area where the leading edge vortex attaches to the wing surface increases, and the vortices that fall off behind the flapping-wing are also difficult to dissipate, which lead to the increasing of the lift force of the flapping-wing. At the same time, the strength and range of influence of the wingtip vortex become larger, which lead to the increasing of the drag force of the flapping-wing.

Total 2