AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (3.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Publishing Language: Chinese | Open Access

The effect of cell aspect ratio on flow and heat transfer characteristics of anisotropic Kelvin foam

Chao ZHANG1,2, Xiangzhuang KONG1,2, Yanxia DU2, Xian WANG1, Guangming XIAO2( )
State Key Laboratory for Strength and Vibration of Mechanical Structures, Shaanxi Key Laboratory of Environment and Control for Flight Vehicle, School of Aerospace Engineering, Xi’an Jiaotong University, Xi’an 710049, China
State Key Laboratory of Aerodynamics, Mianyang 621000, China
Show Author Information

Abstract

High-porosity foam materials are widely used in aircraft thermal management systems due to their light weight and large surface area. The optimization of the geometric parameters in pore scale is crucial for effectively improving the overall heat transfer performance and reducing the structural weight. This paper focuses on anisotropic Kelvin foam structures and uses a hybrid lattice Boltzmann method and multi-GPU acceleration technology to perform conjugate heat transfer numerical simulations that considers both foam skeleton conduction and forced convection heat transfer in the pores on the pore scale. Different cell aspect ratios (H/D = 0.5, 0.75, 1.0, 1.5, 2.0) were selected with various Reynolds numbers (Re = 10, 100, 1000) to study the effect of cell aspect ratio on flow and heat transfer characteristics. The results show that under different Re conditions, as the H/D of the anisotropic Kelvin foam decreases, the flow resistance and Nusselt number inside the foam increase. As the Reynolds number increases, the effect of convective heat transfer becomes stronger, and the influence of H/D becomes more significant. In addition, compared with flow resistance, the structural heat transfer performance changes more rapidly with H/D, and therefore, the comprehensive heat transfer factor is inversely proportional to H/D, which means reducing the H/D of Kelvin foams can effectively improve the overall heat transfer performance of foam structure.

CLC number: V211.3;TG154;V435+.14 Document code: A

References

【1】
【1】
 
 
Acta Aerodynamica Sinica
Pages 55-66

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHANG C, KONG X, DU Y, et al. The effect of cell aspect ratio on flow and heat transfer characteristics of anisotropic Kelvin foam. Acta Aerodynamica Sinica, 2024, 42(1): 55-66. https://doi.org/10.7638/kqdlxxb-2023.0059

620

Views

6

Downloads

0

Crossref

0

Scopus

1

CSCD

Received: 20 April 2023
Revised: 10 June 2023
Published: 17 August 2023
© The journal of Acta Aerodynamica Sinica.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).