This work explored possibilities of biodegradable magnesium alloy Mg-3Y preparation by two modern powder metallurgy techniques – spark plasma sintering (SPS) and selective laser melting (SLM). The powder material was consolidated by both methods utilising optimised parameters, which led to very low porosity (~0.3%) in the SLM material and unmeasurably low porosity in the SPS material. The main aim of the study was the thorough microstructure characterisation and interrelation between the microstructure and the functional properties, such as mechanical strength, deformability, and corrosion resistance. Both materials showed comparable strength of ~110 MPa in tension and compression and relatively good deformability of ~9% and ~21% for the SLM and SPS materials, respectively. The corrosion resistance of the SPS material in 0.1 M NaCl solution was superior to the SLM one and comparable to the conventional extruded material. The digital image correlation during loading and the cross-section analysis of the corrosion layers revealed that the residual porosity and large strained grains have the dominant negative effect on the functional properties of the SLM material. On the other hand, one of the primary outcomes of this study is that the SPS consolidation method is very effective in the preparation of the W3 biodegradable alloy, resulting in material with convenient mechanical and degradation properties that might find practical applications.
- Article type
- Year
Open Access
Full Length Article
Issue
Open Access
Full Length Article
Issue
This work investigated the effect of sole yttrium and neodymium alloying on the microstructure formation during severe plastic deformation by equal channel angular pressing (ECAP) and an impact on the mechanical strength and corrosion resistance of binary Mg-3Y and Mg-3Nd alloys. The results are compared with a ternary Mg-4Y-3Nd alloy, which represents a simplified version of the commercially successful WE43 alloy. The extensive study comprises a thorough microstructural analysis performed by scanning and transmission electron microscopy, including electron backscatter diffraction and texture analysis performed by X-ray diffraction. It is shown that the presence of Nd primarily caused precipitation during the processing of the Mg-3Nd alloy, while Y remained dissolved in the magnesium matrix in the Mg-3Y alloy. This difference resulted in a significantly smaller average grain size in the Mg-3Y alloy (~0.77 nm) than in the Mg-3Nd alloy (~1.3 µm) after the final step of the processing and formation of a slightly different texture. Consequently, the composition and the processing affected the mechanical and corrosion properties of the investigated materials, measured by compression deformation tests, microhardness measurement, and electrochemical impedance spectroscopy. This study shows that the ECAP-processed W3 sample exhibits a surprisingly good combination of ultrafine-grain structure, weak crystallographic texture, high strength, and high corrosion resistance compared with the other investigated samples. These attributes make this material very interesting for utilisation in the industry and/or medicine.
京公网安备11010802044758号