Sort:
Open Access Full Length Article Issue
Re-entry rocket basic flow characteristics and thermal environment of different retro-propulsion modes
Chinese Journal of Aeronautics 2024, 37(7): 190-203
Published: 10 May 2024
Abstract Collect

During the supersonic re-entry of multi-nozzle heavy rockets into the atmosphere, the basic flow state becomes increasingly complex due to the coupling effect between the retro-propulsion plumes and the freestream. A numerical method using the hybrid Reynolds-Averaged Navier-Stokes and Large Eddy Simulation (RES) method and discrete coordinate method is developed to accurately estimate the thermal environment. In addition, finite rate chemical kinetics is used to calculate the afterburning reactions. The numerical results agree well with wind tunnel data, which confirms the validity and accuracy of the numerical method. Computations are conducted for the heavy carrier rocket re-entry from 53.1 km to 39.5 km altitude with 180° angle of attack by using three different Supersonic Retro-Propulsion (SRP) modes. The numerical results reveal that these three SRP flow fields are all Short Penetration Models (SPM). As the re-entry altitudes decrease, both the plume-plume interaction and the plume-freestream interaction become weaker. The highest temperatures in the plume shear layers of the three SRP modes increase by 8.36%, 7.33% and 6.92% respectively after considering afterburning reactions, and all occur at a re-entry altitude of 39.5 km. As the rocket re-enters the atmosphere, the maximum heat flux on the rocket base plate of three SRP modes stabilizes at 290, 170 and 200 kW/m2 respectively, but the maximum heat flux on the side wall increases significantly. When the altitude declines to 39.5 km, the extreme heat flux of the three modes increase by 84.16%, 49.45% and 62.97% respectively compared to that at 53.1 km.

Open Access Research Article Issue
Analysis on the thermal environment at the bottom of a secondary rocket equipped with an auxiliary power system
Acta Aerodynamica Sinica 2024, 42(7): 48-57
Published: 26 September 2023
Abstract PDF (2.6 MB) Collect
Downloads:6

Certain secondary launch vehicle has complex spatial layouts of the auxiliary power system engine, which cause a harsher thermal environment where a large number of components are at the bottom of the rocket body. To address the aforementioned situation, research on the thermal environment at the bottom of the rocket body during the operation of the high-altitude secondary launch vehicle's auxiliary power system is conducted by means of a combined approach which are method of numerical simulation and of wind tunnel testing for validation. Based on the Navier-Stokes component transport equation, the DOM thermal radiation model, and the RNG k-ε model, a gas jet model of a two-stage launch vehicle with complex bottom components at high altitudes has been established. The calculation results indicate that in the operation of the auxiliary power system, the high heat flux regions of the second-stage launch vehicle are mainly concentrated in the short shell behind the fuel tank and the auxiliary power system support. The peak heat flux at the support during the operation of the submerged engine is 300%-400% higher than that of the other components. When the 60 N and 300 N engines operate in the same direction, the heat flux of the other bottom components reaches its peak, with an increase of 300%-600% compared to the other operating conditions. With increasing flight altitude and velocity, the heat flow of each bottom component shows a decreasing trend but with a small magnitude. The calculation results provide important engineering guidance for the thermal protection design of the bottom of the second-stage launch vehicle.

Total 2