AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Re-entry rocket basic flow characteristics and thermal environment of different retro-propulsion modes

Yifei SUa, Peijie SUNb, Yangwen CUIc, Guigao LEa( )
School of Mechanical Engineering, Nanjing University of Science and Technology, Nanjing 210094, China
Shanghai Institute of Aerospace System Engineering, Shanghai 200000, China
Southwest Institute of Technology and Engineering, Chongqing 400039, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

During the supersonic re-entry of multi-nozzle heavy rockets into the atmosphere, the basic flow state becomes increasingly complex due to the coupling effect between the retro-propulsion plumes and the freestream. A numerical method using the hybrid Reynolds-Averaged Navier-Stokes and Large Eddy Simulation (RES) method and discrete coordinate method is developed to accurately estimate the thermal environment. In addition, finite rate chemical kinetics is used to calculate the afterburning reactions. The numerical results agree well with wind tunnel data, which confirms the validity and accuracy of the numerical method. Computations are conducted for the heavy carrier rocket re-entry from 53.1 km to 39.5 km altitude with 180° angle of attack by using three different Supersonic Retro-Propulsion (SRP) modes. The numerical results reveal that these three SRP flow fields are all Short Penetration Models (SPM). As the re-entry altitudes decrease, both the plume-plume interaction and the plume-freestream interaction become weaker. The highest temperatures in the plume shear layers of the three SRP modes increase by 8.36%, 7.33% and 6.92% respectively after considering afterburning reactions, and all occur at a re-entry altitude of 39.5 km. As the rocket re-enters the atmosphere, the maximum heat flux on the rocket base plate of three SRP modes stabilizes at 290, 170 and 200 kW/m2 respectively, but the maximum heat flux on the side wall increases significantly. When the altitude declines to 39.5 km, the extreme heat flux of the three modes increase by 84.16%, 49.45% and 62.97% respectively compared to that at 53.1 km.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 190-203

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SU Y, SUN P, CUI Y, et al. Re-entry rocket basic flow characteristics and thermal environment of different retro-propulsion modes. Chinese Journal of Aeronautics, 2024, 37(7): 190-203. https://doi.org/10.1016/j.cja.2024.05.001

1856

Views

15

Crossref

11

Web of Science

16

Scopus

0

CSCD

Received: 04 August 2023
Revised: 09 October 2023
Accepted: 04 December 2023
Published: 10 May 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).