AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.6 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Publishing Language: Chinese | Open Access

Analysis on the thermal environment at the bottom of a secondary rocket equipped with an auxiliary power system

Zhongyi SUN1, Shuya WANG2, Zhiyuan WEI2, Guigao LE1( )
School of Mechanical Engineering, Nanjing University of Science and Technology, Nanjing 210094, China
708 Research Institute of China Shipbuilding Industry Corporation, Shanghai 200000, China
Show Author Information

Abstract

Certain secondary launch vehicle has complex spatial layouts of the auxiliary power system engine, which cause a harsher thermal environment where a large number of components are at the bottom of the rocket body. To address the aforementioned situation, research on the thermal environment at the bottom of the rocket body during the operation of the high-altitude secondary launch vehicle's auxiliary power system is conducted by means of a combined approach which are method of numerical simulation and of wind tunnel testing for validation. Based on the Navier-Stokes component transport equation, the DOM thermal radiation model, and the RNG k-ε model, a gas jet model of a two-stage launch vehicle with complex bottom components at high altitudes has been established. The calculation results indicate that in the operation of the auxiliary power system, the high heat flux regions of the second-stage launch vehicle are mainly concentrated in the short shell behind the fuel tank and the auxiliary power system support. The peak heat flux at the support during the operation of the submerged engine is 300%-400% higher than that of the other components. When the 60 N and 300 N engines operate in the same direction, the heat flux of the other bottom components reaches its peak, with an increase of 300%-600% compared to the other operating conditions. With increasing flight altitude and velocity, the heat flow of each bottom component shows a decreasing trend but with a small magnitude. The calculation results provide important engineering guidance for the thermal protection design of the bottom of the second-stage launch vehicle.

CLC number: V421.1 Document code: A

References

【1】
【1】
 
 
Acta Aerodynamica Sinica
Pages 48-57

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SUN Z, WANG S, WEI Z, et al. Analysis on the thermal environment at the bottom of a secondary rocket equipped with an auxiliary power system. Acta Aerodynamica Sinica, 2024, 42(7): 48-57. https://doi.org/10.7638/kqdlxxb-2023.0106

577

Views

6

Downloads

0

Crossref

1

Scopus

1

CSCD

Received: 20 June 2023
Revised: 22 August 2023
Published: 26 September 2023
© The journal of Acta Aerodynamica Sinica.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).