This paper describes the orbit design of the deployable payload Rover 2 of MINERVA-II, installed on the Hayabusa2 spacecraft. Because Rover 2 did not have surface exploration capabilities, the operation team decided to experiment with a new strategy for its deployment to the surface. The rover was ejected at a high altitude and made a semi-hard landing on the surface of the asteroid Ryugu after several orbits. Based on the orbital analysis around Ryugu, the expected collision speed was tolerable for the rover to function post-impact. Because the rover could not control its position, its motion was entirely governed by the initial conditions. Thus, the largest challenge was to insert the rover into a stable orbit (despite its large release uncertainty), and avoid its escape from Ryugu due to an environment strongly perturbed by solar radiation pressure and gravitational irregularities. This study investigates the solution space of the orbit around Ryugu and evaluates the orbit’s robustness by utilizing Monte Carlo simulations to determine the orbit insertion policy. Upon analyzing the flight data of the rover operation, we verified that the rover orbited Ryugu for more than one period and established the possibility of a novel method for estimating the gravity of an asteroid.

Subsurface exploration is one of the most ambitious scientific objectives of the Hayabusa2 mission. A small device called small carry-on impactor (SCI) was developed to create an artificial crater on the surface of asteroid Ryugu. This enables us to sample subsurface materials, which will provide a window to the past. The physical properties of the resulting crater are also useful for understanding the internal structure of Ryugu. Accurate understanding of the crater and ejecta properties, including the depth of excavation of subsurface materials, requires accurate information on impact conditions. In particular, the impact angle is a critical factor because it greatly influences the size and shape of the crater. On April 5, 2019, the Hayabusa2 spacecraft deployed the SCI at 500 m of altitude above the asteroid surface. The SCI gradually reduced its altitude, and it shot a 2 kg copper projectile into the asteroid 40 min after separation. Estimating the position of the released SCI is essential for determining the impact angle. This study describes the motion reconstruction of the SCI based on the actual operation data. The results indicate that the SCI was released with high accuracy.