Sort:
Open Access Issue
Turbulence-induced disturbances and their evolution to stall onset in a compressor cascade using large eddy simulation
Chinese Journal of Aeronautics 2026, 39(2)
Published: 17 March 2025
Abstract Collect

This study investigates the turbulence-induced disturbances and stall precursor triggering mechanism in NACA65-18(10) cascade based on large eddy simulations. The results indicate that the disturbances exist under various operating conditions along the performance curve. The shear layer is the physical structure responsible for the generation, propagation, and dissipation of disturbances. When operating near stall, the separation on the suction surface intensifies, and strong unsteady backflow occurs at the trailing edge of the passage. Under the influence of inlet disturbances, unsteady behaviors between passages form specific phase differences, leading the entire system to oscillate in a first-order mode. As the flow develops from near-stall to stall, axial momentum decreases further, reducing the main flow’s ability to drive blockages downstream through convection. Consequently, the blockage accumulates during the circumferential propagation process until the stall onset. Based on the above mechanism, this study proposes factors describing the size of the backflow zone, shedding frequency, and convection velocity to characterize blockage dynamics, identifying critical values that represent the stall onset.

Open Access Full Length Article Issue
Experimental investigation of instability inception on a transonic compressor under various inlet guide vanes
Chinese Journal of Aeronautics 2025, 38(3)
Published: 04 September 2024
Abstract Collect

The utilization of Inlet Guide Vane (IGV) plays a key factor in affecting the instability evolution. Existing literature mainly focuses on the effect of IGV on instability inception that occurs in the rotor region. However, with the emergence of compressor instability starting from the stator region, the mechanism of various instability inceptions that occurs in different blade rows due to the change of IGV angles should be further examined. In this study, experiments were focused on three types of instability inceptions observed previously in a 1.5-stage axial flow compressor. To analyze the conversion of stall evolutions, the compressor rotating speed was set to 17160 r/min, at which both the blade loading in the stator hub region and rotor tip region were close to the critical value before final compressor stall. Meanwhile, the dynamic test points with high-response were placed to monitor the pressures both at the stator trailing edges and rotor tips. The results indicate that the variation of reaction determines the region where initial instability occurs. Indeed, negative pre-rotation of the inlet guide vane leads to high-reaction, initiating stall disturbance from the rotor region. Positive pre-rotation results in low-reaction, initiating stall disturbance from the stator region. Furthermore, the type of instability evolution is affected by the radial loading distribution under different IGV angles. Specifically, a spike-type inception occurs at the rotor blade tip with a large angle of attack at the rotor inlet (−2°, −4° and −6°). Meanwhile, the critical total pressure ratio at the rotor tip is 1.40 near stall. As the angle of attack decreases, the stator blade loading reaches its critical boundary, with a value of approximately 1.35. At this moment, if the rotor tip maintains high blade loading similar to the stator hub, the partial surge occurs (0° and +2°); otherwise, the hub instability occurs (+4° and +6°).

Total 2