Thermal insulation structure is the key factor to ensure high-speed aircraft work safely and complete various tasks. The multilayer thermal insulation structure has attracted much attention because of its light weight and excellent thermal insulation effect. The performance of the multilayer thermal insulation structure is not only related to the physical size but also closely related to the material optimization and the temperature influence. In this paper, the transient nonlinear heat transfer model of the multilayer thermal insulation structure was established, and the numerical solution strategy of the heat transfer equation was proposed. Then, by considering the material optimization, introducing the temperature variation characteristic of the thermal conductivity of the material, and taking the geometric dimensions and equivalent mechanical properties of the multilayer thermal insulation structures as the optimization constraints, an integrated mechanical-thermal optimization model of the multilayer thermal insulation structure was established. The Monte-Carlo method and the particle swarm method were utilized to obtain the solution. The simulation results show that the proposed optimization model and method can reduce the structural mass by 27.4%. The temperature effect analysis shows that the temperature variation effect has an important influence on the optimization results. If the temperature effect on the material properties is not considered, the optimal design scheme may not meet the temperature design constraints, which further leads to structural failure. Finally, the reliability and rationality of the optimization scheme are verified by the finite element model. The optimization design method of the multilayer thermal insulation structure proposed in the paper provides technical support and lays a foundation for the overall design of high-speed aircraft.
- Article type
- Year
- Co-author
Open Access
Issue
A large amount of research work has been conducted on the design of high speed waveriders and engine inlets based on the streamline tracking method, but the integrated design of the forebody of hypersonic vehicles and the scramjet inlet has always been difficult. In order to improve the total pressure recovery and flow capture performance of the integrated forebody and inlet of hypersonic vehicles, the entire base flowfield is divided into a shock compression and an isentropic compression in sequence based on the methods of previous waverider forebody design and inlet compression surface streamline tracing, and a completely continuous streamline tracing is achieved connecting the forebody shockwave, the outer compression surface, the inner compression surface of the inlet, the reflection shockwaves and the inlet throat. The generation of the three-dimensional spanwise surface is controlled by a osculating method, which realizes the design of continuous stream surface. The longitudinal base flowfield is constructed by combining the shock compression flowfield generated by the cross-marching characteristic method with the isentropic compression flowfield generated by the reversed Prandtl-Meyer flow, which only requires constrains of the forebody shockwave shape and the inlet throat. All control lines are described by a kind of quartic spline curve. This is a unified method for the integrated forebody and inlet design of hypersonic vehicles based on reference flowfields of the internal and external cones. Its main advantages are that it has relatively higher flow capture and total pressure recovery coefficients and can be widely used in the integrated design of internal and external flow of hypersonic vehicles.
京公网安备11010802044758号