Sort:
Open Access Just Accepted
Prediction of aerodynamic characteristics in the transitional flow regime based on the modified bridge function
Acta Aerodynamica Sinica
Available online: 12 October 2026
Abstract PDF (2.2 MB) Collect
Downloads:3

To address the requirement for evaluating the aerodynamic characteristics of spacecraft during interplanetary entry in the rarefied transitional flow regime, a novel bridge-function method balancing efficiency and accuracy is proposed based on the sine bridge function. Using the direct simulation Monte Carlo (DSMC) numerical results of the rarefied Martian rarefied as the basis, the effectiveness of this method is evaluated in detail. The results show that the proposed bridge function method can effectively assess the aerodynamic forces in the transition flow regime; compared with Lockheed's sine bridge function, the proposed method significantly improves the computational accuracy; compared with the Erf-log bridge function, this method can calculate multiple aerodynamic force coefficients in the transition flow region based on given single-point numerical results, achieving high computational efficiency. Additionally, the results are insensitive to the selection of the altitude for single-point numerical simulation, there by reducing the DSMC simulation workload and providing technical support for the rapid evaluation of the aerodynamic characteristics of vehicles in the transition flow region.

Open Access Research Article Issue
Molecular dynamics simulation of gas-solid interaction on the surface of ultra-low orbit spacecraft
Acta Aerodynamica Sinica 2025, 43(11): 27-34
Published: 28 February 2025
Abstract PDF (845.4 KB) Collect
Downloads:10

In order to accurately simulate the aerodynamic characteristics and optimize the aerodynamic layout of spacecraft in ultra-low orbit, based on the physical mechanism of high-speed incoming gas and wall interaction faced by ultra-low orbit spacecraft, molecular dynamics methods were used to analyze the influence and mechanism of incoming gas parameters (gas temperature, macroscopic incoming gas velocity, velocity direction) and solid surface conditions (wall temperature) on the momentum and energy accommodation coefficient in the gas-surface interaction process. Research has shown that accurate calculation of momentum and energy accommodation coefficients requires consideration of the combined effects of gas dynamic parameters and wall conditions. Within the wall temperature range of 150-450 K, as the wall temperature increases, the tangential momentum accommodation coefficient remains almost unchanged, while the normal momentum accommodation coefficient and energy accommodation coefficient decrease. The tangential momentum exchange between gas and wall is not sensitive to the change of wall temperature. In the range of macroscopic inflow gas temperature from 500 K to 2000 K, as the macroscopic inflow gas temperature increases, the tangential momentum accommodation coefficient remains almost unchanged, while the normal momentum accommodation coefficient and energy accommodation coefficient increase. The magnitude and direction of macroscopic incoming gas velocity have a coupling effect on the accommodation coefficient. Within the range of macroscopic incoming gas velocity from 100 m/s to 1100 m/s, tangential velocity and normal velocity have opposite effects on the tangential momentum accommodation coefficient. An increase in tangential velocity leads to a decrease in the tangential momentum accommodation coefficient, while an increase in normal velocity leads to an increase in the tangential momentum accommodation coefficient. Therefore, the accurate momentum and energy accommodation coefficients are the result of the combined action of gas parameters and solid surface conditions.

Issue
Aerodynamic layout optimization design of upper atmosphere aircraft
Acta Aeronautica et Astronautica Sinica 2024, 45(22): 130164
Published: 25 November 2024
Abstract PDF (1.3 MB) Collect
Downloads:13

Optimization of the aerodynamic layout of square, hexagonal and circular upper atmosphere aircraft with different cross sections under constant volume was studied by using the test particle Monte Carlo(TPMC)method. The aspect ratio of the aircraft body with the minimum drag force is obtained. Based on this body, the auto-trim aerodynamic layout of the aircraft including the solar cell wing configuration is determined. Finally, the stability of the aircraft is analyzed. The results show that at the upper atmosphere of 250 km, the fraction of friction force in drag of the aircraft body is relatively large, increasing with the increase of the aspect ratio of the aircraft body. When the aspect ratio is 12.98, the total drag of the aircraft body is the smallest. The total drag force coefficient of the aircraft body varies linearly with its aspect ratio under constant volume, while the friction force coefficient and the pressure force coefficient remain constant. In three kinds of cross section shapes mentioned above, the total drag force of the square section is the greatest, followed by that of the hexagon and the circle. For the solar cell wing structure, the wing deflection angles of the aircraft inauto-strim state are 33.8° and 18° for the first solar section deflection configuration(Configuration 1)and the total three solar section deflection configuration(Configuration 2), respectively. For the aircraft wing in auto-strim state, Configuration 1 is superior when considering the heat dissipation of the aircraft body. Regarding installation deviation, when the center of the aircraft is shifted to the bottom of the aircraft, it is in a statically unstable state, and when the center of mass is shifted to the head of the aircraft, it is in a statically stable state.

Total 3