AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (1.3 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Aerodynamic layout optimization design of upper atmosphere aircraft

Junhong LI1,2, Fei HUANG1,2( ), Xuhong JIN1,2, Wenbo MIAO1,2, Xiaoli CHENG1,2
China Academy of Aerospace Aerodynamics, Beijing 100074, China
Laboratory of Aero-thermal Protection Technology for Aerospace Vehicles, China Aerospace Science and Technology Corporation, Beijing 100074, China
Show Author Information

Abstract

Optimization of the aerodynamic layout of square, hexagonal and circular upper atmosphere aircraft with different cross sections under constant volume was studied by using the test particle Monte Carlo(TPMC)method. The aspect ratio of the aircraft body with the minimum drag force is obtained. Based on this body, the auto-trim aerodynamic layout of the aircraft including the solar cell wing configuration is determined. Finally, the stability of the aircraft is analyzed. The results show that at the upper atmosphere of 250 km, the fraction of friction force in drag of the aircraft body is relatively large, increasing with the increase of the aspect ratio of the aircraft body. When the aspect ratio is 12.98, the total drag of the aircraft body is the smallest. The total drag force coefficient of the aircraft body varies linearly with its aspect ratio under constant volume, while the friction force coefficient and the pressure force coefficient remain constant. In three kinds of cross section shapes mentioned above, the total drag force of the square section is the greatest, followed by that of the hexagon and the circle. For the solar cell wing structure, the wing deflection angles of the aircraft inauto-strim state are 33.8° and 18° for the first solar section deflection configuration(Configuration 1)and the total three solar section deflection configuration(Configuration 2), respectively. For the aircraft wing in auto-strim state, Configuration 1 is superior when considering the heat dissipation of the aircraft body. Regarding installation deviation, when the center of the aircraft is shifted to the bottom of the aircraft, it is in a statically unstable state, and when the center of mass is shifted to the head of the aircraft, it is in a statically stable state.

CLC number: V411.3 Document code: A Article ID: 1000-6893(2024)22-130164-10

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica
Article number: 130164

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LI J, HUANG F, JIN X, et al. Aerodynamic layout optimization design of upper atmosphere aircraft. Acta Aeronautica et Astronautica Sinica, 2024, 45(22): 130164. https://doi.org/10.7527/S1000-6893.2024.30164

1046

Views

13

Downloads

0

Crossref

3

Scopus

1

CSCD

Received: 16 January 2024
Revised: 18 February 2024
Accepted: 21 March 2024
Published: 25 November 2024
© 2024 The Journal of Acta Aeronautica et Astronautica Sinica