Natural gas hydrates represent a promising clean energy resource, whose multiphase evolution in subsea sediments, especially in association with seafloor gas seepage and bubble formation, remains poorly understood at the pore scale. To address this gap, this study aimed to quantitatively investigate how bubble size modulates the kinetics of hydrate formation and dissociation by employing high-pressure microfluidics under seafloor reservoir-relevant thermodynamic conditions. In-situ visualization uncovered a two-stage formation mechanism around gas bubbles: Rapid hydrate shell formation followed by gradual shell densification. The shell formation was found to be governed by local gas concentration gradients and exhibited a “chain induction” effect between adjacent bubbles, while the densification duration scaled linearly with bubble size. Likewise, hydrate dissociation was shown to follow a two-stage pathway: The internal hydrate dissociates rapidly in the initial stage, after which the remaining hydrate dissociates much more slowly because the intact dense outer shell restricts outward gas diffusion and internal pressure buildup weakens the thermodynamic driving force. These findings reveal the bubble-size-regulated pore-scale mechanism, providing a kinetic foundation for the dynamic optimization of natural gas hydrate exploitation.
- Article type
- Year
- Co-author
Open Access
Original Article
Issue
Open Access
Original Paper
Issue
Radial well filled with phase change material has been proposed as a novel sand control method for hydrate exploitation. In order to reveal the sand control mechanism, CFD-DEM coupling method is applied to simulate the migration, settlement, and blockage processes of sand particles in the radial well. The obtained results indicate that three scenarios have been recognized for sand particles passing through sand control medium, based on the diameter ratio of sand control medium to sand particle (Dd): fully passing (Dd = 8.75–22.5), partially passing and partially blocked (Dd = 3.18–5.63), and completely blocked (Dd = 2.18–3.21). After being captured by the sand control medium, sand particles can block pores, which increases fluid flow resistance and causes a certain pressure difference in the radial well. The pressure in the radial well should be lower than the hydrate phase equilibrium pressure during sand control design, for the purpose of promoting hydrate decomposition, and sand capture. The length of the radial well should be optimized based on the reservoir pore pressure, production pressure difference, bottom hole pressure, and the pressure gradient in the radial well. It should be noticed that the sand control medium leads to a decrease in permeability after sand particles captured. Even the permeability is reduced to several hundred millidarcy, it is still sufficient to ensure the effective flow of gas and water after hydrate decomposition. Increasing fluid velocity reduces the blocking capacity of the sand control medium, mainly because of deterioration in bridging between sand particles.
京公网安备11010802044758号