Publications
Sort:
Open Access Research Article Just Accepted
Boosting triboelectric nanogenerators via hierarchical textures: insights from coupled adhesion contact and electrical modeling
Nano Research
Available online: 22 October 2026
Abstract PDF (11.5 MB) Collect
Downloads:6

Triboelectric nanogenerators (TENGs) are an emerging nanotechnology for distributed energy harvesting, where introducing hierarchical micro/nanotextures onto contact interfaces effectively enhances electrical output. However, existing theoretical models lack the capability to guide the design of hierarchical textures, particularly overlooking the gap-dependent variation of surface charge density, which is a key factor governing the electrical output. Here, a comprehensive numerical model coupling adhesive contact mechanics with electrical performance is established for hierarchical textured TENGs, with the gap-dependent charge density explicitly incorporated.  The effects of texture hierarchy and micro/nano texture sizes are quantitatively analyzed based on numerical algorithms such as bi-conjugate stabilized (Bi-CGSTAB) method and fast Fourier transform (FFT) technique. It is shown that the present model achieves significantly improved agreement with experimental measurements compared with the conventional constant-charge-density assumption. Under a large indentation depth, hierarchical textures yield an open-circuit voltage of up to 295.7 V, representing an enhancement of 7.97% over single-scale textures, while reducing the pull-off force by 84.6% to effectively prevent separation failure and the consequent voltage degradation. At a small indentation depth, hierarchical textures offer an optimal trade-off between high output and low adhesion. Notably, nanotexture size exerts a dominant regulatory influence on output performance, with larger nanotexture sizes significantly boosting the open-circuit voltage, whereas microtexture size shows a weaker effect. These quantitative insights provide theoretical references for texture design and performance optimization of high-output hierarchical textured TENGs.

Open Access Research Article Issue
Anisotropic tribology and electrification properties of sliding-mode triboelectric nanogenerator with groove textures
Friction 2024, 12(8): 1828-1837
Published: 07 May 2024
Abstract PDF (2.8 MB) Collect
Downloads:145

Sliding-mode triboelectric nanogenerator (S-TENG) is based on the coupling of triboelectrification and electrostatic induction, converting electrical energy from sliding motion. Introducing micro-textures into the sliding surface, and adjusting the angle between the texture and sliding direction (direction angle) may achieve performance anisotropy, which provides novel ideas for optimizing the tribology and electrification performance of S-TENG. To guide the performance optimization based on the anisotropy, in this paper, groove micro-textures were fabricated on the surface of S-TENG, and anisotropic tribology and electrification performance were obtained through changing the direction angle. Based on the surface analysis and after-cleaning tests, the mechanism of the anisotropy was explained. It is shown that the anisotropy of friction coefficient can be attributed to the changes of texture edge induced resistance and groove captured wear debris, while the voltage anisotropy is due to the variations of debris accumulated on the sliding interface and the resulting charge neutralization. Among the selected 0°–90° direction angles, S-TENG at angle of 90° exhibits relatively small stable friction coefficient and high open-circuit voltage, and thus it is recommended for the performance optimization. The open-circuit voltage is not directly associated with the friction coefficient, but closely related to the wear debris accumulated on the sliding interface. This study presents a simple and convenient method to optimize the performance of S-TENG, and help understand the correlation between its tribology and electrical performance.

Total 2