Sort:
Issue
Fuel distribution characteristics of variable area injector with lobe structure
Acta Aeronautica et Astronautica Sinica 2025, 46(22)
Published: 30 June 2025
Abstract PDF (25 MB) Collect
Downloads:10

The flow rate of the extra-cylinder of the variable-cycle engine will change greatly with the transition of the working mode, and the corresponding internal/external contour blending flow brings challenges to the fuel injection scheme of the afterburner. In order to solve this problem, this paper numerically simulates the fuel distribution characteristics of afterburner in variable cycle engine under different modes, explores the influence of wide-range airflow change on fuel distribution, and forms a fuel injection optimization strategy for multi-modal afterburner. The results show that the velocity component of the afterburner mixture along the radial direction and the flow vortex induced by the lobe mixer are the key factors affecting the radial/circumferential diffusion of the fuel, respectively. In the small bypass ratio mode, the connotation-dominated high-temperature and high-speed flow makes the fuel diffusion velocity relatively consistent in a wide range. However, the radial velocity and vortex distribution of the gas change significantly in the large bypass ratio mode, resulting in obvious differences in the fuel diffusion velocity in different regions, which affects the uniformity of fuel distribution. On this basis, an optimization strategy is proposed to moderately increase the fuel flow rate of the nozzle at the middle position, and the results show that the uniformity of fuel distribution will be increased by up to 33.04%.

Open Access Full Length Article Issue
Numerical study of steady flow characteristics of a rear variable-area bypass injector with alternating area regulator
Chinese Journal of Aeronautics 2024, 37(5): 180-198
Published: 29 January 2024
Abstract Collect

The mixing effectiveness of the airflow between the inner and outer bypass inlets of a Rear Variable-Area Bypass Injector (RVABI) is the key to the afterburner performance of variable cycle engines. This paper describes an optimized RVABI design based on an alternating area regulator to improve the velocity/temperature uniformity of the incoming flow at the afterburner. Compared with a classical RVABI, numerical simulations show that the proposed alternating RVABI performs better in terms of thermal mixing efficiency and total pressure loss in different variable cycle engine modes. Both the increasing air contact area between the inner and outer bypass of alternating structure RVABI, and a larger streamwise vortex in the inner bypass inlet due to the proposed alternating lobe structure in the RVABI contribute to the significantly increase of mixing effectiveness. Besides, the alternating regulator induces strong streamwise vortex, which helps to improve the airflow mixing with its vortex-induced velocity. The interaction between the streamwise vortex and azimuthal vortex further promises the velocity/temperature uniformity after the RVABI. With the increase of alternating lobe’s height ratio, the covering area of the streamwise vortex and the azimuthal vortex is enlarged, which further enhances the thermal mixing efficiency of the RVABI. This design gives an insight into the future design and optimization of RVABI.

Total 2