The mixing effectiveness of the airflow between the inner and outer bypass inlets of a Rear Variable-Area Bypass Injector (RVABI) is the key to the afterburner performance of variable cycle engines. This paper describes an optimized RVABI design based on an alternating area regulator to improve the velocity/temperature uniformity of the incoming flow at the afterburner. Compared with a classical RVABI, numerical simulations show that the proposed alternating RVABI performs better in terms of thermal mixing efficiency and total pressure loss in different variable cycle engine modes. Both the increasing air contact area between the inner and outer bypass of alternating structure RVABI, and a larger streamwise vortex in the inner bypass inlet due to the proposed alternating lobe structure in the RVABI contribute to the significantly increase of mixing effectiveness. Besides, the alternating regulator induces strong streamwise vortex, which helps to improve the airflow mixing with its vortex-induced velocity. The interaction between the streamwise vortex and azimuthal vortex further promises the velocity/temperature uniformity after the RVABI. With the increase of alternating lobe’s height ratio, the covering area of the streamwise vortex and the azimuthal vortex is enlarged, which further enhances the thermal mixing efficiency of the RVABI. This design gives an insight into the future design and optimization of RVABI.
- Article type
- Year
- Co-author
Open Access
Full Length Article
Issue
Open Access
Full Length Article
Issue
Ammonia (NH3) is currently considered to be a potential carbon-free alternative fuel, and its large-scale use as such would certainly decrease greenhouse gas emissions and meet increasingly stringent emission requirements. Although the low flame propagation speed and high NO production of NH3 hinder its direct application as a renewable fuel, co-combustion of NH3–H2 is an effective way to overcome these challenges. In this study, the combustion characteristics of NH3–H2 swirling flames under different equivalence ratios and H2 blending ratios conditions are both numerically and experimentally investigated. Numerically, the One-Dimensional (1D) laminar flame computation presents a comparison base and the Three-Dimensional (3D) numerical simulation yields detailed flame property distributions. Experimentally, the high-speed camera takes instantaneous swirl flame images and the gas analyzer measures the NO emission at the exit plane of the flame chamber. Qualitative and quantitative analysis is performed on the flame structure and NO emission for a series of NH3–H2 swirl flames. The variation trends of the NO emission calculated using different techniques agree very well. The quantitative results show that the NO emissions are much higher at lean equivalence ratios than those at rich equivalence ratios, and such difference is closely related to the combustion flame structure. Moreover, it is shown that the utilization of secondary air injection can achieve a significant reduction in NO emissions at the exit of the combustion chamber at equivalence ratios less than or equal to 0.9.
京公网安备11010802044758号