Predicting the thickness of Thermally Grown Oxide (TGO) and the residual stresses induced by TGO growth in the Thermal Barrier Coatings (TBCs) is significant work in analyzing the failure of TBCs. In practical applications, the operating temperature, oxygen partial pressure, aluminium content in TBCs, and porosity of the topcoat affect the oxidation rate. Therefore, a novel oxidation rate model is proposed to describe the effect of such factors. The parameters in the proposed model were fitted with isothermal degradation test data from prior literature. Then, a method for calculating the residual stress in a disk-shaped specimen was developed based on the oxidized growth strain model and the oxidized model. Finally, a variable-temperature oxidation experiment was performed to validate the new oxidation model. The average error between the predicted and experimental thicknesses is approximately 10%, and the average error between the residual stresses is 30%. Under the variable-temperature condition, the error between the predicted thickness and the average experimental thickness is 3.9%.
- Article type
- Year
Open Access
Full Length Article
Issue
Open Access
Full Length Article
Issue
Experimental and numerical investigations were performed to reveal the effect of prestress on the fatigue properties of FGH4097 so as to quantitatively evaluate the overspeed benefit of the disc of aeroengine. A corresponding experiment was performed to examine the effect of prestress on the fatigue life of FGH97. A complete model describing the fatigue properties of the prestressed notch specimen was proposed. After the modification of mean stress, stress gradient and prestressing treatment, the model is finally verified by fatigue test of presstressed notch specimens machined from FGH4097 with satisfactory accuracy and good engineering applicability. The new model highlights that for the variable fatigue loads, the introduction of appropriate prestress is expected to benefit to the notch specimens and certainly to the disc of aeroengine regards of their fatigue properties. Both the calculation method of fatigue life parameters and the prestress correction model are proved to have good prediction accuracy.
京公网安备11010802044758号