The continuous evolution of chip manufacturing demands the development of materials with ultra-low dielectric constants. With advantageous dielectric and mechanical properties, initiated chemical vapor deposited (iCVD) poly(1,3,5-trimethyl-1,3,5-trivinyl cyclotrisiloxane) (pV3D3) emerges as a promising candidate. However, previous works have not explored etching for this cyclosiloxane polymer thin film, which is indispensable for potential applications to the back-end-of-line fabrication. Here, we developed an etching process utilizing O2/Ar remote plasma for cyclic removal of iCVD pV3D3 thin film at sub-nanometer scale. We employed in-situ quartz crystal microbalance to investigate the process parameters including the plasma power, plasma duration and O2 flow rate. X-ray photoelectron spectroscopy and cross-sectional microscopy reveal the formation of an oxidized skin layer during the etching process. This skin layer further substantiates an etching mechanism driven by surface oxidation and sputtering. Additionally, this oxidized skin layer leads to improved elastic modulus and hardness and acts as a barrier layer for protecting the bottom cyclosiloxane polymer from further oxidation.
- Article type
- Year
- Co-author
Open Access
Paper
Issue
Open Access
Paper
Issue
Polymer-derived ceramic (PDC) thin films are promising wear-resistant coatings for protecting metals and carbon–carbon composites from corrosion and oxidation. However, the high pyrolysis temperature hinders the applications on substrate materials with low melting points. We report a new synthesis route for PDC coatings using initiated chemical vapor deposited poly(1,3,5-trivinyl-1,3,5-trimethylcyclotrisiloxane) (pV3D3) as the precursor. We investigated the changes in siloxane moieties and the network topology, and proposed a three-stage mechanism for the thermal annealing process. The rise of the connectivity number for the structures obtained at increased annealing temperatures was found with strong correlation to the enhanced mechanical properties and thermal conductivity. Our PDC films obtained via annealing at 850 ℃ exhibit at least 14.6% higher hardness than prior reports for PDCs synthesized below 1100 ℃. Furthermore, thermal conductivity up to 1.02 W (mK)−1 was achieved at the annealing temperature as low as 700 ℃, which is on the same order of magnitude as PDCs obtained above 1100 ℃. Using minimum thermal conductivity models, we found that the thermal transport is dominated by diffusons in the films below the percolation of rigidity, while ultra-short mean-free path phonons contribute to the thermal conductivity of the films above the percolation threshold. The findings of this work provide new insights for the development of wear-resistant and thermally conductive PDC thin films for durable protection coatings.
京公网安备11010802044758号