AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Paper | Open Access

Remote plasma enhanced cyclic etching of a cyclosiloxane polymer thin film

Xianglin Wang1,2,3, Xinyu Luo1,2,3 , Weiwei Du1,2, Yuanhao Shen1,2, Xiaocheng Huang1,2, Zheng Yang2, Junjie Zhao1,2 ( )
State Key Laboratory of Chemical Engineering, College of Chemical and Biological Engineering, Zhejiang University, 866 Yuhangtang Rd, Hangzhou 310058, People’s Republic of China
Institute of Zhejiang University - Quzhou, 99 Zheda Rd, Quzhou, Zhejiang 324000, People’s Republic of China

3 These authors contributed equally.

Show Author Information

Abstract

The continuous evolution of chip manufacturing demands the development of materials with ultra-low dielectric constants. With advantageous dielectric and mechanical properties, initiated chemical vapor deposited (iCVD) poly(1,3,5-trimethyl-1,3,5-trivinyl cyclotrisiloxane) (pV3D3) emerges as a promising candidate. However, previous works have not explored etching for this cyclosiloxane polymer thin film, which is indispensable for potential applications to the back-end-of-line fabrication. Here, we developed an etching process utilizing O2/Ar remote plasma for cyclic removal of iCVD pV3D3 thin film at sub-nanometer scale. We employed in-situ quartz crystal microbalance to investigate the process parameters including the plasma power, plasma duration and O2 flow rate. X-ray photoelectron spectroscopy and cross-sectional microscopy reveal the formation of an oxidized skin layer during the etching process. This skin layer further substantiates an etching mechanism driven by surface oxidation and sputtering. Additionally, this oxidized skin layer leads to improved elastic modulus and hardness and acts as a barrier layer for protecting the bottom cyclosiloxane polymer from further oxidation.

References

【1】
【1】
 
 
International Journal of Extreme Manufacturing
Article number: 055101

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Wang X, Luo X, Du W, et al. Remote plasma enhanced cyclic etching of a cyclosiloxane polymer thin film. International Journal of Extreme Manufacturing, 2024, 6(5): 055101. https://doi.org/10.1088/2631-7990/ad57a1

522

Views

7

Downloads

8

Crossref

9

Web of Science

10

Scopus

0

CSCD

Received: 29 February 2024
Revised: 07 April 2024
Accepted: 12 June 2024
Published: 04 July 2024
© 2024 The Author(s).

Original content from this work may be used under the terms of the Creative Commons Attribution 4.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.