Aurivillius-type CaBi2Nb2O9 (CBN) is attractive for high-temperature ultrasonic sensing owing to its high Curie temperature (TC ≈ 940 ℃). However, its weak piezoelectric response and loss of polarization alignment during thermal exposure limit its practical performance. Herein, K/Ce/Sm co-substitution at the Ca site was employed to modify the lattice structure, electrical transport, and domain morphology of CBN ceramics. Co-substitution reduced the orthorhombic distortion while preserving the orthorhombic framework. The optimized CBN-KCS-12 ceramic exhibited a piezoelectric coefficient d33 of 18 pC/N, a TC of approximately 933 ℃, and a ρdc resistivity of 2.59 × 106 Ω·cm at 650 ℃, approximately 18.5 times that of undoped CBN. The annealing temperature corresponding to 50% retention of the initial d₃₃ increased from 600 to 850 ℃, and CBN-KCS-12 retained approximately 44% of its initial d33 after annealing at 900 ℃. Piezoresponse force microscopy revealed larger block-like regions in CBN-KCS-12 compared with the fine stripe-like patterns in undoped CBN, with block-like contrast also observed after annealing at 900 ℃. The elastic modulus also increased from 30.1 to 33.8 GPa. Finally, a single-element ultrasonic transducer fabricated from CBN-KCS-12 produced clear pulse-echo signals from room temperature to 400 ℃, achieving a signal-to-noise ratio above 36 dB and a -6 dB fractional bandwidth of approximately 42% at 400 °C. These results demonstrate the potential of multi-element A-site co-substitution for improving CBN ceramics for high-temperature ultrasonic applications.
- Article type
- Year
- Co-author
Open Access
Research Article
Just Accepted
Open Access
Research Article
Issue
K0.5Bi4.5Ti4O15 (KBT, Curie temperature TC = 558 °C), a representative Aurivillius-type ferroelectric material, is considered a promising candidate for high-temperature piezoelectric devices. In this study, the co-doping strategy was adopted by introducing Li/Mn ions into the A-site of KBT, and a series of polycrystalline ceramics with the formula (KBi)0.5−x(LiMn)xBi4Ti4O15 (x = 0–0.065, abbreviated as KBT–LM1000x) were synthesized via the conventional solid-state reaction method. The substitution mechanisms of Li/Mn ions and their doping concentration effects on the crystalline structure, defect chemistry, and dielectric/ferroelectric properties were investigated. The synergistic substitution of Li/Mn for K/Bi induced a transition of KBT in its dielectric behavior from a sharp λ-type anomaly to a diffuse or relaxor-like response, with both diffuseness parameter γ and TC values gradually increasing with increasing x. The Li/Mn co-doping strategy effectively suppressed the leakage conduction of KBT, achieving balanced control of conduction suppression and domain-wall mobility. Among the systems, KBM55 achieved the highest piezoelectric coefficient (d33 = 30 pC/N) and planar electromechanical coupling factor (kp = 6.4%), as well as a higher Curie temperature (TC = 590 °C). Furthermore, an ultrasonic transducer was fabricated by using this sample as conversion elements, which demonstrated a center frequency (fc) of 2.24 MHz, a −6 dB bandwidth (BW–6 dB) of 33.95%, and stable pulse–echo signals up to 250 °C.
京公网安备11010802044758号