Publications
Sort:
Open Access Research paper Issue
CMAS corrosion and wetting behaviour of porous microstructure in thermal barrier coatings
Journal of Aeronautical Materials 2026, 46(11): 100-109
Published: 15 November 2026
Abstract PDF (20.7 MB) Collect
Downloads:0

The work aims to investigate the CMAS(calcia-magnesia-aluminosilicate) corrosion behavior of plasma co-sprayed YSZ(yttria-stabilized zirconia) coatings obtained at different gun speeds. The thermal barrier coatings prepared by plasma co-spraying at different gun traverse speeds are subjected to CMAS corrosion at high-temperature. The penetration of CMAS in the coating is studied by scanning electron microscopy and energy dispersive X-ray spectroscopy. The wetting behavior of CMAS on the coating is investigated using the seat drop method, and the effects of roughness on the corrosion and wetting of CMAS are studied. Results show that the coatings prepared at a gun speed of 600 mm/s does not exhibit delamination after CMAS corrosion at 1300 ℃/1 h, and has the best resistance to CMAS corrosion penetration. In CMAS wetting experiments, coatings prepared at a gun speed of 100 mm/s have significant advantages in resisting CMAS wetting behavior. The roughness Ra of the coating ranges from 3.47 μm to 3.77 μm, with little difference, which eliminates the influence of roughness on wetting behavior. The CMAS tiling barrier on the embedded particle formation structure on the coating surface is the reason for the poor wetting performance at the low gun speed in this experiment. The difference in the structure of embedded particles on the surface and inside of the coating is the main factor that results in good CMAS penetration resistance at high gun speed.

Total 1