Publications
Sort:
Open Access Issue
Effects of methylcellulose on the surface mechanical behavior and wear mitigation mechanism of stainless-steel grippers
Journal of Beijing University of Chemical Technology (Natural Science Edition) 2026, 53(5): 69-79
Published: 20 September 2026
Abstract PDF (10.3 MB) Collect
Downloads:0

The surface tribological behavior of stainless-steel gripping claws exerts a decisive influence on their service life. A plane-to-plane friction and wear tester was employed to simulate the surface tribological behavior of the gripping claws during actuation. Methylcellulose (MC) was applied to the contact interfaces of five stainless steel pairs to replicate the operating conditions of the gripping claws, followed by tribological testing and characterization analysis. This study investigated the effect of MC in mitigating wear of different steel materials and revealed its friction-reducing and anti-wear mechanisms. The results demonstrate that wear on the gripping claw surface is primarily concentrated at the claw tip and the front segment of the claw body. Tribological test results indicate that the friction coefficient exhibits a decreasing trend with increasing load; when the load reaches 25 N, the friction coefficient between 321 stainless steel and MC is as low as 0.014. Additionally, the steel material itself has a significant impact on the friction coefficient, with Ti-containing 321 stainless steel demonstrating the optimal friction-reducing performance. The mechanism involves friction-induced effects that facilitate the formation of adsorbed and molten transfer films of MC on the stainless steel surface. These transfer films effectively isolate the direct contact between the upper and lower friction pairs, thereby enhancing lubrication efficiency while significantly attenuating abrasive wear and adhesive wear.

Total 1