Publications
Sort:
Open Access Issue
Effect of water inflow methods on flow field and suitability for aquaculture in rectangular farming tanks
South China Fisheries Science 2024, 20(6): 121-131
Published: 05 December 2024
Abstract PDF (2 MB) Collect
Downloads:0

To improve the suitability for fish, we conducted a study on the hydrodynamic characteristics of the internal flow field by different water inflow methods. Firstly, we constructed a numerical model of the fish tanks in a 300 000-ton aquaculture vessel by using Computational Fluid Dynamics (CFD) technology, and validated its feasibility of the numerical method. On this basis, we analyzed the hydrodynamic characteristics such as flow velocity distribution, fluid uniformity and resistance coefficient, and evaluated the effects of the area proportion of flow velocity suitable for fishing and the state of bottom flow field on the fitness level of Pseudosciaena crocea. The results indicate that changes in the number of daily water exchange affected the flow velocity magnitude within the aquaculture tank significantly. As the number of daily exchange decreased from 16 to 10, the average flow velocity inside the tank dropped by 46.7%. Conversely, the changes in the number of inlet ports had a considerable impact on the uniformity of water flow. When the number of inlets reduced from 16 to 4, the fluid uniformity index inside the tank decreased by 18.4%. When altering the placement of inlet ports, it is crucial to pay attention to the interactions between the inflow jets. Comprehensive analysis shows that it is the most beneficial for the culture of P. crocea with 16 times of daily water change, and by evenly arranging the 16 water intakes at the cut corners of rectangular tank.

Open Access Issue
Study on large yellow croaker's pellet feed behavior using acoustic signals
South China Fisheries Science 2025, 21(3): 64-71
Published: 05 June 2025
Abstract PDF (1 MB) Collect
Downloads:0

In recent years, China has achieved remarkable achievement in deep-sea aquaculture of large yellow croaker(Larimichthys crocea), not only in terms of production, but also in terms of quality. Nevertheless, feeding operations are affected by natural calamities such as typhoons and powerful ocean currents. Therefore, to further improve the technological development of L. crocea culture in deep sea, we used the fish with an initial body mass of (122.62±11.08) g and a body length of (17.9±1.04) cm as samples, then applied an underwater acoustic measurement system (Bandwidth of 20 Hz−20 kHz) to capture the underwater sound and observe the behavioral responses of the fish. The results indicate that the feeding sound of the fish could be distinctly classified into two types: pure swallowing and swallowing accompanied by chewing. Both swallowing and chewing produced sound mainly within the frequency of 6 Hz−13 kHz. Prior to feeding, the acoustic signals emitted by the fish were relatively sparse. However, when the feeding began, the number of acoustic signals increased significantly. In a single feeding cycle, an individual fish exhibited 4−7 feeding behaviors, with pure swallowing being relatively infrequent. Swallowing wasusually accompanied by 1−2 pulsed acoustic signals. Single pulses had a shorter duration, while double pulses had a longer one. The duration of these signals ranged from 0.05 to 0.25 sec, and the average sound pressure level generated was approximately (74.51±3.91) dB. When chewing, the fish most commonly produced 5−7 chews, with the chewing intensity gradually decreasing from (73.27±2.62) to (55.82±1.43) dB. Furthermore, as the number of feeding behaviors increased, the foraging duration of the fish also extended significantly, displaying a linear positive correlation.

Open Access Issue
Optimization of inlet and outlet configurations for rectangular aquaculture tanks based on model experiments
South China Fisheries Science 2025, 21(3): 24-35
Published: 05 June 2025
Abstract PDF (14.6 MB) Collect
Downloads:0

As the core functional unit of aquaculture platforms, aquaculture tank has advantages and disadvantages of its inlet and outlet configurations which have a significant impact on its internal flow field environment. To optimize the hydrodynamic conditions and enhance production efficiency, we established a 1:100 scale physical model based on a 300,000-ton-class rectangular aquaculture tank, employing Particle Image Velocimetry (PIV) for systematic hydrodynamic experimentation. By controlling key parameters including inflow rate and number of inlets, we quantitatively analyzed the evolution characteristics of flow field structures under different inflow conditions. Besides, we investigated the mechanisms by which various outlet structuresaffect vortex field characteristics within the tank. The results demonstrate that: 1) Inflow rate was the primary regulating factor for flow velocity. When the inflow decreased from 1 800 L·h−1 to 900 L·h−1, the high-velocity zone proportion decreased from 33.2% to 8.4%, the low-velocity zone expanded to over 65% of the tank volume, and the average velocity decreased by 52.89%, showing a linear correlation between inflow rate and average velocity. 2) Adjusting the number of inlets was more effective than flow rate modification in improving flow field uniformity. Reducing the number of water inlet decreased the DU50 uniformity coefficient by up to 33.62% across different depths under identical conditions, and up to 39.68% across different conditions at the same cross-section. 3) Variation in the quantity and position of bottom outlets significantly influenced the vortex fieldcharacteristics within the aquaculture tank. When four outlets were installed at the bottom, the vortex effects on the water inside the aquaculture tanks could be effectively avoided.

Total 3