Publications
Sort:
Issue
Research progress and prospect of swirl/total pressure combined distortion test and evaluation
Acta Aeronautica et Astronautica Sinica 2026, 47(7)
Published: 14 November 2025
Abstract PDF (48.2 MB) Collect
Downloads:27

Guided by the compatibility assessment for the next-generation advanced stealth aircraft's intake/engine, this paper reviews the research progress and development directions of aeroengine swirl/total pressure combined distortion testing and evaluation techniques. Focusing on distorted flow field testing, the principles and technical challenges of typical steady/dynamic probe measurements in flow fields with airflow deviation angles are introduced. The difficulties in applying conventional measurement point distributions to complex swirl/total pressure combined distortion pattern testing are analyzed. Regarding the design of distortion generators, the structural composition and principles of commonly used total pressure and swirl distortion generators are summarized, and the design approaches and challenges of typical combined swirl/total pressure distortion generators are outlined. In terms of distortion index definition, various methods for defining total pressure and swirl distortion indices, along with their correlation to engine stability, are listed. Two approaches for correlating combined swirl/total pressure distortion intensity with engine stability are presented, and the necessity of developing a combined swirl/total pressure distortion index is discussed. Based on the current state of technology domestically and internationally, key technical directions for future research are explored, including accurate steady/dynamic flow field testing under large airflow deflection angles, design of measurement point distributions for complex combined distortion patterns, efficient design and continuous adjustability of combined distortion generators, and the definition of combined distortion indices that reflect changes in engine stability.

Open Access Research Article Issue
Effect on near-wall region flow by an array of dielectric barrierdischarge plasma actuators
Acta Aerodynamica Sinica 2022, 40(2): 50-58
Published: 06 September 2021
Abstract PDF (3 MB) Collect
Downloads:4

In order to reveal the flow state dependence of the control effect by alternating current surface dielectric barrier discharge (AC-SDBD) plasma actuation, an array of eight AC-SDBD plasma actuators was designed, and the influence on the flow in the near-wall region was investigated for the mainstream velocity ranging from 20 m/s to 80 m/s. The experimental results show that the array of AC-SDBD plasma actuators can significantly increase the velocity in the near-wall region initially, which eventually drops a bit before finally stabilizes. After the flow reaches a new stable state, the influence range of the plasma actuation can extent as far as 170 mm downstream of the actuators and 10 mm in the wall-normal direction, respectively. Moreover, the velocity distribution near the wall under the plasma actuation depends on the streamwise and wall-normal locations. When the mainstream velocity is small, the plasma actuation increases the near-wall velocity after stabilization, but when the mainstream velocity is above a certain value, the near-wall velocity after the plasma actuation is lower than the corresponding no actuated case.

Total 2