The Hydro-Viscous Drive (HVD) speed regulating system finds extensive application in air transport transmission systems to regulate the stepless speed or conduct overload protection. However, its intrinsic hysteretic behaviors, such as the asymmetric hysteretic and dead zone, could introduce inaccuracy and delay in control applications, posing challenges to system regulation. This paper investigates a Nonlinear Hysteresis Compensation Control (NHCC) that consists of two parts to control the HVD output speed by operating the valve under different engine operating conditions. In the first part, the Inverse Hysteresis Compensator (IHC) based on major loop data is introduced for the asymmetric hysteresis characterization and compensation of the HVD speed control system of the power generation and distribution, which aims to reduce the hysteresis and dead zone effect and expand the effective input range. In the second part, the Active Disturbance Rejection Controller (ADRC) is employed to mitigate the hysteresis effects of the compensated system and remove the steady-state error, which allows real-time compensation of the estimated perturbations as state feedback to achieve the required performance. An experimental laboratory station has been fabricated to evaluate the proposed method. The test results show that the NHCC method can regulate the fan speed to the desired value (|e| 45 r/min at steady state) and broaden the effective input range to the full range under different engine conditions. Besides, the proposed control method can reduce the non-linearity of the input and output curves (from 18% to 4%) and compensate for the asymmetric hysteresis (from 38% to 5%).
- Article type
- Year
Open Access
Full Length Article
Issue
The paper proposes a method that joins two line segments using planar Pythagorean hodograph (PH) degree 7 Bezier transition curves. The objective is to make use of such curvature-continuous curves for the path planning of nonholonomic constrained vehicles moving in 2D space, which requires designing a smooth path while satisfying the constraint of minimum turning radius. We initially present a novel idea that employs PH degree 7 Bezier transition curves for dealing with curvature constraints, the result of which proves to be better than the traditional method based on the “forward simulation”. The properties of PH degree 7 Bezier transition curves are then fully analyzed showing that the curves can be determined by a minimum of three parameters, each of which has an intuitive geometric meaning. The paper also proposes a path planner with direct curvature constraints during the process of path generation in 2D space. The objective function of the optimal path generation can be adjusted to minimize the length of the whole path or to closely follow the original global nonsmooth sequences of line segments. Here, the optimization problem is tactfully converted to a linear programming problem that can be solved efficiently. Finally, we use a kinematic bicycle model for simulation and compare the results with those from Dubins path showing that a G2 curve is easier to follow than a G1 one.
京公网安备11010802044758号