A new demodulation algorithm of the fiber-optic Fabry-Perot cavity length based on the phase generated carrier (PGC) is proposed in this paper, which can be applied in the high-temperature pressure sensor. This new algorithm based on arc tangent function outputs two orthogonal signals by utilizing an optical system, which is designed based on the field-programmable gate array (FPGA) to overcome the range limit of the original PGC arc tangent function demodulation algorithm. The simulation and analysis are also carried on. According to the analysis of demodulation speed and precision, the simulation of different numbers of sampling points, and measurement results of the pressure sensor, the arc tangent function demodulation method has good demodulation results: 1 MHz processing speed of single data and less than 1% error showing practical feasibility in the fiber-optic Fabry-Perot cavity length demodulation of the Fabry-Perot high-temperature pressure sensor.

This paper proposes the design and research on the high bandwidth linear frequency sweep signal source involved in the readout unit module of the wireless passive pressure sensor in high temperature based on the principle of mutual inductance coupling which is applied widely at present. The operating principle of the linear sweep frequency source based on the direct digital frequency synthesis (DDS) technology is introduced, and the implementation method of the hardware circuit and logic sequential control process required in our system has been realized utilizing this technology. Through the experiments under different conditions of the step value, the sweep range and other related design indicators, the influence on the extraction method of resonance frequency information, extraction accuracy, and others during the readout system of the mutual inductance coupling sensor are analyzed and studied. The design of the linear frequency sweep signal source is realized with a resonance frequency change resolution of 6kHz, a minimum step value of 1 kHz, and a precision of frequency for 0.116Hz within the sweep width of 1MHz – 100MHz. Due to the use of the integrated commercial chip, the linear sweep frequency source is made small in size, high working frequency, high resolution and low step values for the readout unit modularized of a higher application value.