A novel optical fiber hydrogen sensor based on the π-phase-shifted grating and partial coated Pd/Hf composite film is proposed and experimentally demonstrated in this paper. The hydrogen sensitive Pd/Hf film with the length of 4 mm is successfully deposited in the π-phase-shifted grating region by the magnetron sputtering process and rotating fixture technology. Since the hydrogen sensitivity between the notch and flank wavelengths of the π-phase-shifted grating is different due to the partial coating only on the π-phase-shifted grating region, the relative shift between the notch and flank wavelengths is employed to characterize the hydrogen concentration in this paper. The hydrogen calibration results show that the sensor shows the good response and repeatability. At the temperature of 20 ℃ and the hydrogen concentration of 2%, the wavelength distance shifts of 200 nm and 500 nm Pd/Hf coatings are 12.6 pm and 33.5 pm, respectively.

In recent years, detecting and quantifying multiple gases have garnered widespread attention across various fields, particularly in volatile organic compound (VOC) detection, which holds significant importance for ecosystems and the medical field. The Raman spectroscopy has been widely used in multi-gas detection due to its advantages in fast response speed and non-destructive detection. This paper reviews the latest research progress of the multi-gas sensing technology in the Raman spectroscopy, focusing on using the hollow-core fiber to enhance the gas signal intensity. The basic principles of the fiber-enhanced Raman spectroscopy are introduced. The detailed discussion includes the system architecture, parameter configuration, and experimental results. Then, the latest advances in the coherent anti-Stokes Raman scattering multi-gas detection technology are reviewed. Finally, the challenges faced by the hollow-core fiber in practical applications are discussed.

Fiber Bragg grating (FBG) array is a powerful technique for quasi-distributed sensing along the entire length of sensing fiber with fast response and high precision. It has been widely used for temperature, strain, and vibration monitoring. In this review work, an overview on the recent advances of FBG arrays is conducted. Firstly, the fabrication methods of FBG array are reviewed, which include femtosecond laser system and online writing technique. Then, the demodulation techniques for FBG arrays are presented and discussed. Distributed static sensing can be performed by demodulating wavelength shift of each FBG, while phase demodulation techniques with low noise are employed for dynamic vibration sensing. Simultaneous distributed dynamic and static sensing system based on FBG array is also outlined. Finally, possible future directions are discussed and concluded. It is believed that the FBG array has great development potential and application prospect.

A fiber-optic shape sensing based on 7-core fiber Bragg gratings (FBGs) is proposed and experimentally demonstrated. The investigations are presented for two-dimensional (2D) and three-dimensional (3D) shape reconstruction by distinguishing bending and twisting of 7-core optical fiber with FBGs. The curvature and bending orientation can be calculated by acquiring FBG wavelengths from any two side cores among the six outer cores. And the shape sensing in 3D space is computed by analytic geometry theory. The experiments corresponding of 2D and 3D shape sensing are demonstrated and conducted to verify the theoretical principles. The resolution of curvature is about 0.1m^–1 for 2D measuring. The error of angle in shape reconstruction is about 1.89° for 3D measuring. The proposed sensing technique based on 7-core FBGs is promising of high feasibility, stability, and repeatability, especially for the distinguishing ability on the bending orientation due to the six symmetrical cores on the cross-section.

An improved glucose sensitive membrane (GSM) is prepared by immobilizing glucose oxidase (GOD) onto a mixture of silica mesocellular foams (SiMCFs) and SiO₂ nanoparticles (SiNPs) and then trapping it in a polyvinyl alcohol (PVA) gel. The membrane is coated onto a gold-glass sheet to create a surface plasmon resonance (SPR) sensor. A series of experiments are conducted to determine the optimized parameters of the proposed GSM. For a GSM with a component ratio of SiMCFs:SiNPs=7:3 (mass rate), the resonance angle of the sensor decreases from 68.57° to 63.36°, and the average sensitivity is 0.026°/(mg/dL) in a glucose concentration range of 0 mg/dL ‒ 200mg/dL. For a GSM with a component ratio of SiMCFs:SiNPs=5:5 (mass rate), the resonance angle of the sensor decreases from 67.93° to 63.50°, and the sensitivity is 0.028°/(mg/dL) in a glucose concentration range of 0mg/dL ‒ 160mg/dL. These data suggest that the sensor proposed in this study is more sensitive and has a broader measurement range compared with those reported in the literature to date.

This paper reviews the work on huge capacity fiber-optic sensing network based on ultra-weak draw tower gratings developed at the National Engineering Laboratory for Fiber Optic Sensing Technology (NEL-FOST), Wuhan University of Technology, China. A versatile drawing tower grating sensor network based on ultra-weak fiber Bragg gratings (FBGs) is firstly proposed and demonstrated. The sensing network is interrogated with time- and wavelength-division multiplexing method, which is very promising for the large-scale sensing network.

Hydrogen is one of the next generation energies in the future, which shows promising applications in aerospace and chemical industries. Hydrogen leakage monitoring is very dangerous and important because of its low ignition energy, high combustion efficiency, and smallest molecule. This paper reviews the state-of-art development of the fiber optic hydrogen sensing technology. The main developing trends of fiber optic hydrogen sensors are based on two kinds of hydrogen sensitive materials, i.e. palladium-alloy thin films and Pt-doped WO₃ coatings. In this review work, the advantages and disadvantages of these two kinds of sensing technologies will be evaluated.

The combination of fiber optics with nano-structure technologies and sensitive thin films offers great potential for the realization of novel sensor concepts. Miniatured optical fiber sensors with thin films as sensitive elements could open new fields for optical fiber sensor applications. Thin films work as sensitive elements and transducer to get response and feedback from environments, in which optical fibers are employed to work as signal carrier. This article presents some research work conducted at the National Engineering Laboratory for Optical Fiber Sensing Technologies in recent years. Concrete examples are: Pd/WO₃ co-sputtered coating as sensing material for optical hydrogen sensors shows robust mechanical stability and meanwhile good sensing performance; TbDyFe magnetostrictive coating directly deposited on fiber Bragg grating (FBG) demonstrates its possibility of miniature optical magnetic field/current sensors, and 40-pm shift of the FBG wavelength happens at a magnetic field order of 50 mT.