Publications
Sort:
Issue
Uncertainty analysis of non-axisymmetric stagger angle based on NIPC
Acta Aeronautica et Astronautica Sinica 2024, 45(19): 630145
Published: 15 October 2024
Abstract PDF (1.7 MB) Collect
Downloads:4

An uncertainty quantification method based on the non-intrusive polynomial chaos is developed to assess the impacts of non-axisymmetric stagger angle distribution on the aerodynamic performance of compressors. Uncertainty quantification is carried out to analyze the aerodynamic performance of an eight-passage high-pressure compressor rotor with non-axisymmetric stagger angles. The changes of the rotor performance are quantificationally attributed to the variation of the average stagger angle and the nonuniformity. The results show that the mass flow rate and isentropic efficiency at the design point are mainly affected by the nonuniformity, which accounts for 65.6% and 71.8%, respectively, while the pressure ratio is evenly influenced by the average stagger angle and nonuniformity. At the small mass flow point, nonuniformity mainly leads to the decrease of mass flow rate and total pressure ratio, which account for 88.2% and 66.2%, respectively, while the isentropic efficiency is evenly influenced by the average stagger angle and nonuniformity. The radial distribution of isentropic efficiency shows that the uncertainty in isentropic efficiency of radial position below 20% span is mainly caused by the change of the average stagger angle, while the isentropic efficiency at about 30% span is mainly affected by the nonuniformity. The performance and flow field analysis of the extreme cases show that the non-axisymmetric stagger angle distribution mainly affects the isentropic efficiency below 50% span at the small flow rate.

Open Access Full Length Article Issue
Partial rotating instability in a boundary layer ingesting fan
Chinese Journal of Aeronautics 2025, 38(3)
Published: 16 December 2024
Abstract Collect

Rotating Instability (RI) is a typical unsteady flow phenomenon in compressors and may cause severe aerodynamic noise and even potential nonsynchronous vibration. Most studies of RI are based on the uniform inflow, ignoring the influence of inlet distortions. This study investigates the mechanism of RI in a transonic rotor through full-annulus unsteady simulations, with a particular focus on the effects of boundary layer ingesting distortions. The results show that at the uniform inflow, the RI fluctuations with the broadband hump can be observed over a relatively wide mass flow rate range, and its origin can be attributed to the coupling effect between the tip leakage flow and shear layer instability. At the inlet distortions, the broadband hump only occurs with partial circumferential locations. This kind of flow phenomenon is defined as Partial Rotating Instability (PRI). The PRI only occurs in a narrower mass flow rate range in which the circumferential range of strong shear is sufficiently large and the self-induced unsteady effects are strong enough. Further, this study confirms that the averaged tip leakage flow axial momentum at the onset of RI or PRI is close, so it can be used as the parameter to determine whether RI or PRI occurs.

Total 2