Publications
Sort:
Open Access Research paper Issue
Effects of stress ratio and temperature on high-cycle fatigue properties of a single crystal superalloy containing Ru
Journal of Aeronautical Materials 2026, 46(11): 36-45
Published: 15 November 2026
Abstract PDF (11.6 MB) Collect
Downloads:0

The high-cycle fatigue performance of a novel Ru-containing single crystal superalloy is investigated under different stress ratios (0.1, 0.3, and 0.5) and various temperatures (850, 900, 1000, and 1050 ℃). The results show that the fatigue strength of the alloy decreases with the increase of stress ratio, and rises firstly and then drops with increasing temperature, reaching the maximum value at 1000 ℃. Fracture surface morphology is characterized by scanning electron microscopy (SEM). It is found that the fatigue fracture of specimens tested at different stress ratios and temperatures exhibits quasi-cleavage fracture features, and cracks propagate along {111} and {001} planes. As the stress ratio increases, the fracture area of {001} planes perpendicular to the stress axis increases significantly, accompanied by aggravated plastic deformation. Transmission electron microscopy (TEM) is employed to observe the microstructure and dislocation configuration after fatigue deformation. The observations reveal that increasing stress ratio leads to a marked rise in dislocation density. Dislocation pile-ups and dislocation networks form within the γ matrix channels and cut into the γ′ precipitates, which induces dissolution and deformation of γ′ phase. With rising temperature, the γ matrix channels widen. Misfit dislocations are generated under applied stress, which is beneficial to improving the high-temperature mechanical properties of single-crystal superalloys within a certain temperature range.

Issue
Effect of film cooling holes on creep properties of nickel-based single crystal superalloy
Acta Aeronautica et Astronautica Sinica 2024, 45(19): 429737
Published: 15 October 2024
Abstract PDF (3.5 MB) Collect
Downloads:46

In order to meet the increase of the turbine inlet temperature of advanced aeroengines, film cooling is used to reduce the blade temperature. However, the geometrical integrity of the blade structure is destroyed by the film cooling holes, which makes the turbine blade more susceptible to creep damage around the film cooling holes under the influence of centrifugal and thermal stresses. Therefore, it is important to understand the creep performance of nickel-based single crystal superalloys with film cooling holes. The creep damage mechanism of DD6 single crystal superalloy with the cylindrical, dustpan and dovetail film cooling holes were studied through the creep experiment and finite element simulation at 1 000 ℃/300 MPa, and the detailed microscopic characterizations were conducted. The results show that the average creep lives of cylindrical and dustpan holes are similar to each other, and are increased by 17.4% and 15.9% respectively compared with the dovetail hole. Based on the fracture analysis, stress concentration and oxidation around the hole edge led to cracking first. Combined with Scanning Electron Microscope(SEM), Electron Back-Scattered Diffraction (EBSD) and finite element simulation, the plastic deformation zone obtained by EBSD corresponds to the high stress region obtained by finite element analysis, and the γ' phase rafting morphology and the oxidation is related to the stress distribution. Energy Dispersive Spectrometer (EDS) analysis indicates that oxides can be divided into three layers, i. e., the outer layer is mainly NiO and CoO, the middle layer is mainly a mixture of Cr, Ni and Ta oxides, and the inner layer is Al2O3. The γ' free layer occurs adjacent to the oxide layer, and the plastic deformation and γ' phase dissolution around the hole edge facilitate recrystallization formation.

Total 2