Sort:
Open Access Full Length Article Issue
Aerodynamic instability evolution of a multi-stage combined compressor
Chinese Journal of Aeronautics 2025, 38(1): 103182
Published: 13 August 2024
Abstract Collect

Unstable operating conditions such as surge could cause damage to both aerodynamic performance and structural integrity of a compression system. This paper addresses the critical issue of aerodynamic instability in compressor design, particularly focusing on an axial-centrifugal combined compressor, a widely used yet underexplored configuration. An experimental investigation was conducted on a three-stage axial and one-stage centrifugal compressor (3A1C), using two pipe systems and employing fast-responding transducers to capture the dynamic instability process from choke condition to deep surge. Results reveal that at the design speed, 3A1C enters deep surge directly, whereas at off-design speeds, it experiences rotating stall and mild surge across a wide mass flow range. Some special instability features in the combined compressor can be found in the steady state map and dynamic process. The characteristic curve of the first axial stage keeps a positive slope during the whole mass flow range at an off-design speed. The first stage could work stably on the stall characteristic curve because the centrifugal stage has stronger pressurization and plays a dominant role in global aerodynamic instability. Besides, rotating instability occurs at the first rotor tip and disappears as the back pressure increases, which is also rarely seen in a single-axial compressor. This is also related to the strong pressurization of the centrifugal stage. The findings of this paper will contribute to the understanding of aerodynamic instabilities in combined compressors.

Open Access Full Length Article Issue
Compressor geometric uncertainty quantification under conditions from near choke to near stall
Chinese Journal of Aeronautics 2023, 36(3): 16-29
Published: 02 November 2022
Abstract Collect

Geometric and working condition uncertainties are inevitable in a compressor, deviating the compressor performance from the design value. It’s necessary to explore the influence of geometric uncertainty on performance deviation under different working conditions. In this paper, the geometric uncertainty influences at near stall, peak efficiency, and near choke conditions under design speed and low speed are investigated. Firstly, manufacturing geometric uncertainties are analyzed. Next, correlation models between geometry and performance under different working conditions are constructed based on a neural network. Then the Shapley additive explanations (SHAP) method is introduced to explain the output of the neural network. Results show that under real manufacturing uncertainty, the efficiency deviation range is small under the near stall and peak efficiency conditions. However, under the near choke conditions, efficiency is highly sensitive to flow capacity changes caused by geometric uncertainty, leading to a significant increase in the efficiency deviation amplitude, up to a magnitude of −3.6%. Moreover, the tip leading-edge radius and tip thickness are two main factors affecting efficiency deviation. Therefore, to reduce efficiency uncertainty, a compressor should be avoided working near the choke condition, and the tolerances of the tip leading-edge radius and tip thickness should be strictly controlled.

Total 2