Sort:
Open Access Issue
Improved surface integrity in Inconel 718 using small diameter hammer peening tools
Chinese Journal of Aeronautics 2025, 38(7)
Published: 25 April 2025
Abstract Collect

Machine Hammer Peening (MHP) is an emergent treatment that induces high compressive Residual Stresses (RS) which can enhance the in-service performance of components. This paper studies the use of small diameter MHP tools to improve the Surface Integrity (SI) of the nickel-based alloy Inconel 718 used in critical aero-engine components. Complementarily, the relaxation of RS is analyzed by in-situ annealing tests at in-service temperature combined with X-ray diffraction measurement. For this purpose, age hardened Inconel 718 discs were turned as reference condition, and then a pneumatic MHP tool was used under different conditions: two tool diameters (4 mm and 12 mm), feed rates (2.5 m/min and 5.0 m/min) and stepover distances (0.07 mm and 0.35 mm). Subsequently, surface topography characterization, RS measurements, nanoindentation tests, and microstructural observations were conducted. The in-situ annealing tests were done in the X-ray diffractometer at 550 °C for exposure periods from 0 to 20 h. The results demonstrate that 4 mm diameter tools generate smooth surfaces and induce significant compressive RS within a 0.5 mm thick layer. Residual stresses are relaxed, but they remain compressive even after a long thermal exposure. The microstructure of the surface layer (<10–15 μm) was affected by the preceding turning operation, but importantly, MHP did not induce additional damage.

Open Access Full Length Article Issue
Correcting distortions of thin-walled machined parts by machine hammer peening
Chinese Journal of Aeronautics 2024, 37(6): 439-453
Published: 31 October 2023
Abstract Collect

Thin-walled aerostructural components frequently get distorted after the machining process. Reworking to correct distortions or eventually rejecting parts significantly increases the cost. This paper proposes a new approach to correct distortions in thin-walled components by strategically applying hammer peening on target surfaces of a machined component. Aluminium alloy 7475-T7351 was chosen for this research. The study was divided in two stages. First, the residual stresses (RS) induced by four different pneumatic hammer peening conditions (modifying the stepover distance and initial offset) were characterised in a test coupon, and one of the conditions was selected for the next stage. In the second stage, a FEM model was used to predict distortions caused by machining in a representative workpiece. Then, the RS induced by hammer peening were included in an FEM model to define two hammer peening strategies (varying the coverage area) to analyse the capability to reduce distortions. Two workpieces were machined and then treated with the simulated hammer peening strategies for experimental validation. Results in the test coupon showed that pneumatic hammer peening can generate high compressive RS (-50 to −350 MPa) up to 800 μm depth, with their magnitude increasing with a reduced stepover distance. Application of hammer peening over 4 % of the surface of the representative workpiece reduced the machining-induced distortions by 37 %, and a coverage area of 100 % led to and overcorrection by a factor of five. This confirms that hammer peening can be strategically applied (in target areas and changing the percentage of coverage) to correct low or severe distortions.

Total 2