The requirements for green and sustainable manufacturing mean that stamping lubricants must be continuously re-evaluated and re-designed. In this investigation, the tribological performance of four base oils with different chemical structures (paraffinic and naphthenic) and viscosities (2 and 20 cSt), as well as water, was evaluated for the stamping of steel sheets and compared with a non-lubricated contact. Most lubricants reduce the coefficient of friction and maintain a similar wear coefficient for steel sheets as in dry contacts. Low-viscosity (LV) naphthenic oil performs very like both high-viscosity (HV) oils. A surprising exception is the LV paraffinic oil, with several-times-higher friction and wear compared to dry contact. This is due to the excellent wetting-spreading and very low cohesion forces that enable oil to escape from extremely thin-film contacts because the viscosity is so low, leading to lubricant starvation. In contrast, HV oils provide a sufficiently thick lubricating film, while strong cohesive forces help in the film’s strength, lessening wear, and reducing friction. In thin-film lubrication with LV oils, such as when stamping, it is thus extremely important that the lubricant’s wetting behaviour and viscosity are sufficient to provide enough film in the contact and prevent starvation, thus ensuring lower friction, less wear, and a longer lifetime of the contact.

In this work, we evaluated the effect of the counter-body material (the same or dissimilar) and contact configuration (moving or stationary body), at similar contact tribological conditions, on the tribochemical and nanotopography characteristics of adsorbed surface films. Zinc dialkyldithiophosphate (ZDDP), the best performing anti-wear additive, was used in self-mated steel/steel and DLC/DLC contacts, which were compared with mixed steel/DLC and DLC/steel contacts in 1-h and 6-h sliding tests. The macroscale (tribometer) and nanoscale (atomic force microscopy) friction, thickness, topography, and chemical (attenuated total reflection- Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy) properties of the tribofilms were studied. The results revealed unexpectedly large differences in all the studied tribofilm parameters; this is because all the tribofilms are completely different; this includes the chemical composition, which is known to have a crucial effect on the nano- and macro-scale tribological properties. These results clearly demonstrate that the surface material, additives, and common contact operating parameters, that is, pressure, velocity, and temperature, crucially affect the ZDDP tribofilm as well as the position of the moving or stationary surface within the contact, and the material of the moving/stationary bodies.

In this study we present a mechanism for the elastohydrodynamic (EHD) friction reduction in steel/steel contacts, which occurs due to the formation of oleophobic surface boundary layers from common boundary-lubrication additives. Several simple organic additives (amine, alcohol, amide, and fatty acid) with different molecular structures were employed as the model additives. It was found that the stronger chemisorption at 100 ℃, rather than the physisorption at 25 ℃, is more effective in friction reduction, which reaches 22%. What is more, EHD friction reduction was obtained in steel/steel contacts without use of the diamond-like carbon (DLC) coatings with their wetting or thermal effect, which was previously suggested as possible EHD friction reduction mechanism; yet about the same friction reduction of about 20% was obtained here—but with much simpler and less expensive technology, namely with the adsorbed oleophobic surface layers. A small variation in the additive’s molecular structure results in significant changes to the friction, indicating good potential in future EHD lubrication technology, where these additives could be designed and well optimised for notable reduction of the friction losses in the EHD regime.