AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (4.6 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Generation and release mechanism of residual stress and strain in solid rocket motor propellant grain with pressure cure

Jia WEI1,2, Baoshi YU1,2, Dapeng ZHANG1,2( ), Zhibin SHEN1,2, Yongjun LEI1,2,3
College of Aerospace Science and Engineering, National University of Defense Technology, Changsha 410073, China
Hunan Key Laboratory of Intelligent Planning and Simulation for Aerospace Missions, Changsha 410073, China
Rocket Force University of Engineering, Xi'an 710025, China
Show Author Information

Abstract

To investigate the generation and release mechanism of residual stress and strain in solid rocket motor propellant grain with pressure cure, a theoretical model considering the coupling of thermochemical-mechanical multi physics fields during curing and cooling process was developed based on viscoelastic theory, finite difference method, and incremental method. The composition, distribution and evolution laws of residual stress and strain of grain were revealed. The mapping relationships between temperature, degree of cure, residual stress and strain of grain were obtained. The release path of residual stress and strain of grain was optimized. The results showed that the residual stress and strain of grain were mainly caused by the accumulation of three parts: thermal expansion and cure shrinkage during curing stage, and cooling shrinkage during cooling stage. The residual stress caused by three parts accounted for about 5%, 12% and 83% respectively. The residual strain caused by three parts accounted for about −1%, 24% and 77% respectively. During cooling stage, as the temperature of grain decreases, the residual stress and strain linearly increase. Using the proposed theoretical model, the optimal pressure load of pressure cure technology was calculated, which is linearly related to the circumferential elastic modulus of the case. Compared with the conventional pressure cure technology, the optimized technology based on the composition and evolution laws of response can reduce the maximum residual stress and strain during curing and cooling process by an average of about 65.5%.

CLC number: V435;O34 Document code: A Article ID: 1000-6893(2025)16-431661-16

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
WEI J, YU B, ZHANG D, et al. Generation and release mechanism of residual stress and strain in solid rocket motor propellant grain with pressure cure. Acta Aeronautica et Astronautica Sinica, 2025, 46(16). https://doi.org/10.7527/S1000-6893.2025.31661

917

Views

20

Downloads

0

Crossref

1

Scopus

0

CSCD

Received: 13 December 2024
Revised: 31 December 2024
Accepted: 21 January 2025
Published: 06 February 2025
© 2025 The Journal of Acta Aeronautica et Astronautica Sinica