AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (94.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Quasi-in situ electron backscatter diffraction tensile test on deformation mechanisms of laser melting deposited Ti-3Cu alloy

Lihong JIANG( ), Lin ZHU, Zheng LIU
Jiangxi Provincial Key Laboratory of High-End Equipment Extreme Manufacturing Technology, Nanchang Hangkong University, Nanchang 330063, China
Show Author Information

Abstract

Ti-Cu alloys exhibit excellent mechanical properties and corrosion resistance, making them promising candidates for biomedical and aerospace engineering applications. However, their deformation mechanisms remain poorly understood. Quasi-in situ tensile testing combined with Electron Backscatter Diffraction (EBSD) was employed to investigate the microstructural evolution of a Laser Melting Deposited (LMD) Ti-3Cu alloy fabricated via in situ alloying during room-temperature tensile deformation. The results demonstrated heterogeneous orientation rotations within localized regions of individual grains. Dislocations were primarily concentrated at grain and subgrain boundaries, accompanied by a progressive increase in the fraction of Low-Angle Grain Boundaries (LAGBs, 2°-15°) with increasing strain. Analysis of localized grain evolution revealed that α-grains with distinct crystallographic orientations and morphologies underwent non-uniform deformation, where macroscopic strain was accommodated through grain rotation and substructure formation. Quantitative Schmid factor analysis combined with slip trace characterization confirmed the dominance of the prismatic slip system in the Ti-3Cu alloy. These findings provide critical insights into the deformation mechanisms of laser-melting-deposited Ti-Cu alloys, offering guidance for their fabrication and application in advanced technologies.

CLC number: V252.2;TG146 Document code: A Article ID: 1000-6893(2025)22-431642-15

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
JIANG L, ZHU L, LIU Z. Quasi-in situ electron backscatter diffraction tensile test on deformation mechanisms of laser melting deposited Ti-3Cu alloy. Acta Aeronautica et Astronautica Sinica, 2025, 46(22). https://doi.org/10.7527/S1000-6893.2025.31642

807

Views

4

Downloads

0

Crossref

1

Scopus

0

CSCD

Received: 09 December 2024
Revised: 24 February 2025
Accepted: 12 May 2025
Published: 11 June 2025
© 2025 The Journal of Acta Aeronautica et Astronautica Sinica