AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Lattice structure and mechanical properties of TPMS prepared by selective laser melting

Qulong WEI, Lihong JIANG( ), Zheng LIU, Lin ZHU, Lianhai FAN, Guangang WANG, Mingjie ZHAO, Zhenghua GUO
School of Aeronautical Manufacturing and Engineering, Nanchang Hangkong University, Nanchang 330063, China
Show Author Information

Abstract

Triply Period Minimal Surface (TPMS) lattice structures have a wide range of lightweight design prospects due to their lightweight, high strength and energy absorption properties. However, they are difficult to manufacture using traditional methods. Using Ti-6Al-4V powder as the material, lattice samples with different porosities of Gyroidand Primitiveand solid tensile samples were fabricated by Selective Laser Melting (SLM) technique, and the mechanical propertiesand microstructure were analyzed. The results show that the mechanical properties of TPMS tend to decrease with the increase of porosity, and the plasticity of Primitive structure is better than that of Gyroid structure, but the overall strength is lower than that of Gyroid structure. The compressive yield strengthand tensile strength of TPMS lattice structure reach 498 MPaand 373.0 MPa, and the mechanical properties of TPMS lattice structure are better than those based on bar diameter class (boby-centered cubic, face-centered cubic), and the elongation of lattice structure is 2.8% to 14.0% higher than that of solid sample. The fracture modes of the both lattice structures area mixture of toughnessand brittleness. Porosityand unfused powder are present on the surface of the lattice structures, but these microscopic defects do not affect their failure mechanism. The tensile strengthand elongation of the solid tensile sample prepared under the same process parameters reach 1 050 MPaand 17.5%, which is superior to the mechanical properties of traditional cast Ti-6Al-4V alloy.

CLC number: V252 Document code: A Article ID: 1000-6893(2025)03-430593-16

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
WEI Q, JIANG L, LIU Z, et al. Lattice structure and mechanical properties of TPMS prepared by selective laser melting. Acta Aeronautica et Astronautica Sinica, 2025, 46(3). https://doi.org/10.7527/S1000-6893.2024.30593

2417

Views

76

Downloads

0

Crossref

5

Scopus

0

CSCD

Received: 23 April 2024
Revised: 13 May 2024
Accepted: 05 July 2024
Published: 15 February 2025
© 2025 The Journal of Acta Aeronautica et Astronautica Sinica