AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (11.7 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Non-cooperative target extraction in complex industrial environment based on image segmentation

Xiaojun WU( ), Peng WANG, He ZHAO, Xianzhe YU, Tiancheng LI
School of Mechanical and Electrical Engineering, Xi’an University of Architecture and Technology, Xi’an 710055, China
Show Author Information

Abstract

In complex industrial scenes, it is difficult to acquire high-precision non-cooperative target pose under monocular visual servo control. This paper presents a new method of target extraction and high-precision edge fitting for the wheel of the sintering trolley in steel production, which fuses multiple target extraction algorithms adapting to the working environment of the target. Firstly, based on obvious difference between the pixels of the target image and the non-target image in the gray histogram, these pixels were classified and then segmented in intraclass, removing interference factors and remaining the target image. Then, multiple segmentation results were merged and a final target image was obtained after small connected regions were eliminated. In the edge fitting stage, the edge fitting method with best-circumscribed rectangle was proposed to accurately fit the circular target edge. Finally, PnP algorithm was adopted for pose measurement of the target. The experimental results showed that the average estimation error of pose angle γ with respect to the z-axis rotation was 0.2346°, the average measurement error of pose angle α with respect to the x-axis rotation was 0.1703°, and the average measurement error of pose angle β with respect to the y-axis rotation was 0.2275°. The proposed method has practical application value.

References

【1】
【1】
 
 
Journal of Measurement Science and Instrumentation
Pages 119-127

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
WU X, WANG P, ZHAO H, et al. Non-cooperative target extraction in complex industrial environment based on image segmentation. Journal of Measurement Science and Instrumentation, 2025, 16(1): 119-127. https://doi.org/10.62756/jmsi.1674-8042.2025012

608

Views

66

Downloads

0

Crossref

0

CSCD

Received: 25 October 2023
Revised: 12 January 2024
Accepted: 18 January 2024
Published: 01 March 2025
© The Author(s) 2025.

The articles published in this open access journal are distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits use, distribution and reproduction in any medium, provided the original work is properly cited.