AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Home Capillarity Article
PDF (3.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Article | Open Access

Interfacial behavior of thickened CO2 in shale nanoporous media

Center for Petroleum Science and Engineering, Skolkovo Institute of Science and Technology, Moscow 121205, Russia
School of Petroleum Engineering, China University of Petroleum (East China), Qingdao 266580, P. R. China
Show Author Information

Abstract

In CO2-enhanced shale oil recovery process, the low viscosity of CO2 often leads to premature gas breakthrough, compromising sweep efficiency. Previous work demonstrated that 12-hydroxystearic acid and dimethyl sulfoxide can increase bulk CO2 viscosity, yet the behavior of this formulation in water-bearing clay nanopores remains unclear. Molecular dynamics simulations and density functional theory calculations were combined to examine phase partitioning, near-surface interactions, and nanoscale apparent wettability in hydrated illite slit pores. As temperature and CO2 loading increased, dimethyl sulfoxide-water hydrogen bonding decreased, which drove more dimethyl sulfoxide to remain in the main CO2-rich cluster. Within the same hydrated pore, the two formulation components exhibited distinct near-surface dynamics: dimethyl sulfoxide underwent frequent, short-lived residence events, whereas 12-hydroxystearic acid showed fewer but longer water-mediated events. The prolonged residence of 12-hydroxystearic acid was associated with its stronger affinity for the hydrated illite interface. However, surface hydration prevented the carboxyl headgroup from persistent contact anchoring to the interface, as revealed by free-energy and density functional theory calculations. The stronger affinity thus originated from hydrocarbon-chain dispersion rather than carboxyl-group electrostatics, as further indicated by interaction-energy decomposition. The formulation also altered wettability at the nanoscale, as evidenced by a lower water-mediated apparent contact angle. This reduction resulted from the broadening of the oil-water interface and its increased positional fluctuations, caused by dimethyl sulfoxide enrichment at the interface and the three-phase contact line. These findings provide a molecular basis for understanding the behavior of the previously demonstrated CO2-thickening formulation after it enters water-bearing illite nanopores.

Electronic Supplementary Material

Download File(s)
capi-20-2-34_ESM.pdf (1.3 MB)

References

【1】
【1】
 
 
Capillarity
Pages 34-48

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Zhang L, Chen J, Ovsepian M, et al. Interfacial behavior of thickened CO2 in shale nanoporous media. Capillarity, 2026, 20(2): 34-48. https://doi.org/10.46690/capi.2026.08.02

5

Views

0

Downloads

0

Crossref

0

Scopus

Received: 11 June 2026
Revised: 07 July 2026
Accepted: 25 July 2026
Published: 28 July 2026
© The Author(s) 2026.

This article is distributed under the terms and conditions of the Creative Commons Attribution (CC BY-NC-ND) license, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.