AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (854 KB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Article | Open Access

Coupled simulation of pressure and saturation in water flooding using a quantum linear system solver

Physical Science and Engineering Division, King Abdullah University of Science and Technology, Thuwal 23955-6900, Saudi Arabia
College of Science, China University of Petroleum (East China), Qingdao 266580, P. R. China
State Key Laboratory of Deep Oil and Gas, China University of Petroleum (East China), Qingdao 266580, P. R. China
Show Author Information

Abstract

Sequential water flood simulation alternates implicit pressure solves with explicit saturation updates. This study examines, under ideal statevector access, how a solution state produced by the Harrow-Hassidim-Lloyd quantum linear system algorithm can be inserted into that sequential workflow for a two-phase model in one dimension. The evolving pressure systems are preconditioned from the left using rebuilt sparse approximate inverses, converted by Hermitian block dilation, and treated with signed phase estimation at finite resolution. The formulation also identifies the classical normalization, sign recovery, and complete field readout operations required before a solution state can drive the transport update. Steady and transient component tests precede coupled calculations on three successively refined grids. Across these grids, the statevector and direct pressure solutions remain closely aligned in direction, while the finest grid saturation trajectories show the largest difference and the statevector branch reaches the imposed upper saturation bound. Each plotted statevector pressure is aligned by a global scalar with the exact solution of its current dilated system, so the results assess algebraic data exchange rather than an independent reconstruction of physical pressure. A separate pilot covering five steps finds similar directional agreement between pressure solutions when a right sparse approximate inverse is rebuilt or updated using a sparse approximate map, but the combined setup and update time for recycling is markedly longer than the rebuilding time for this small problem. The results show that close directional agreement between pressure solutions does not by itself guarantee accurate saturation transport and thus provide a reference point for assessing such solvers in sequential reservoir simulation. All calculations use ideal statevectors; no quantum hardware, speedup of the complete workflow, or hardware advantage is demonstrated.

References

【1】
【1】
 
 
Advances in Geo-Energy Research
Pages 220-237

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Xu L, Xiang Y, Li M, et al. Coupled simulation of pressure and saturation in water flooding using a quantum linear system solver. Advances in Geo-Energy Research, 2026, 21(3): 220-237. https://doi.org/10.46690/ager.2026.09.03

10

Views

1

Downloads

0

Crossref

0

Web of Science

0

Scopus

Received: 21 June 2026
Revised: 23 July 2026
Accepted: 06 August 2026
Published: 10 August 2026
© The Author(s) 2026.

This article is distributed under the terms and conditions of the Creative Commons Attribution (CC BY-NC-ND) license, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.