AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (39.3 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access

Manufacturing and Joining of Composite Units for On-Orbit Construction of Large Structures in Space

Yuxin Li1,2,3,†, Haitao Luo1,2,†( ), Mingqiang Huang1,4, Qingge Li1,4
State Key Laboratory of Robotics and Intelligent Systems, Shenyang Institute of Automation, Chinese Academy of Sciences, Shenyang 110016, China
Institutes for Robotics and Intelligent Manufacturing, Chinese Academy of Sciences, Shenyang 110169, China
University of Chinese Academy of Sciences, Beijing 100049, China
School of Mechanical Engineering, Shenyang University of Technology, Shenyang 110142, China

†These authors contributed equally to this work.

Show Author Information

Abstract

On-orbit construction eliminates the need to withstand the harsh mechanical environment during the launch phase and is not constrained by the size limitations of a launch vehicle’s fairing. This approach effectively reduces the structural weight of spacecraft and enables the construction of space facilities on scales ranging from hundreds to even thousands of kilometers. Truss-type structures are the primary support structures for large-scale space bodies. Therefore, the 2 key technologies in on-orbit construction are the fabrication of large structural units and the connection between these units. This paper proposes the use of carbon fiber/polyetheretherketone (CF/PEEK) composite prepreg tapes to manufacture composite tubular units through the pultrusion process. The influence of temperature and speed on the mechanical properties of the pultruded tubular units was studied. Additionally, it proposes using 3-dimensionally printed translucent PEEK joints to connect the tubular units, reinforced by laser transmission welding. The effects of welding temperature and speed on the weld strength were analyzed, and the microstructural characteristics of the weld were observed at a microscopic scale. Finally, a parabolic antenna framework was fabricated by cutting CF/PEEK composite tubular units into different lengths, verifying the feasibility of this method for on-orbit construction. This paper offers a valuable technical reference for the advancement of on-orbit construction technology.

References

【1】
【1】
 
 
Space: Science & Technology
Article number: 0333

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Li Y, Luo H, Huang M, et al. Manufacturing and Joining of Composite Units for On-Orbit Construction of Large Structures in Space. Space: Science & Technology, 2026, 6: 0333. https://doi.org/10.34133/space.0333

3

Views

0

Downloads

0

Crossref

0

Web of Science

0

Scopus

Received: 23 August 2024
Revised: 24 March 2025
Accepted: 28 July 2025
Published: 03 April 2026
© 2026 Yuxin Li et al. Exclusive licensee Beijing Institute of Technology Press. No claim to original U.S. Government Works.

Distributed under a Creative Commons Attribution License (CC BY 4.0).