AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (5.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access

Modeling of the Test Mass Release Process Based on Improved Genetic Algorithm Identification and Adhesion Analysis

Wei Wang1, Yanwei Ding1, Yiyan Xu1, Ji Wang2, Diwen Shi2, Bingwei Cai2, Jie Chang2, Hengxu Yang2, Mingpei Lin3, Jinxiu Zhang1, Chao Xue2( )
School of Aeronautics and Astronautics, Sun Yat-sen University, Shenzhen 518107, China
MOE Key Laboratory of TianQin Mission, TianQin Research Center for Gravitational Physics & School of Physics and Astronomy, Frontiers Science Center for TianQin, Gravitational Wave Research Center of CNSA, Sun Yat-sen University (Zhuhai Campus), Zhuhai 519082, China
Advanced Institute for Materials Research, Tohoku University, Sendai 980-8577, Japan
Show Author Information

Abstract

Gravitational waves carry a wealth of cosmic information, offering a new observation perspective for exploring the universe. The grabbing, positioning, and release mechanism is a fundamental element of the gravitational reference sensor used in spaceborne gravitational wave detectors and serves to steadily transition the test mass (TM) from high-load to geodetic conditions. However, implementing comprehensive performance testing on the entire mechanism will inevitably prolong the development period. Conversely, utilizing a dynamic model to predict the behavior of the released TM will facilitate the development and improvement of the mechanism. A dynamic model of the TM release process was established to assess the performance of the release mechanism and analyze the effect of adhesion on TM velocity. Firstly, a dynamic model of the release mechanism was developed, and the unknown parameters were identified using an identification method based on an improved genetic algorithm, which avoids the initial value of the parameters being challenging to guess. Then, considering the roughness of the contact surface between the release tip and the TM, the contact force was analyzed based on the Johnson–Kendall–Roberts theory. The dynamic model of the TM was formulated by incorporating the contact force into the release mechanism dynamic model, and the velocity response of the TM during unilateral release was calculated. Finally, the influence of mechanism parameters on the TM’s velocity was investigated. The TM velocity response indicates that adhesion does not considerably influence the TM velocity. Furthermore, the release mechanism can fulfill the mission requirements under typical release conditions.

References

【1】
【1】
 
 
Space: Science & Technology
Article number: 0315

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Wang W, Ding Y, Xu Y, et al. Modeling of the Test Mass Release Process Based on Improved Genetic Algorithm Identification and Adhesion Analysis. Space: Science & Technology, 2026, 6: 0315. https://doi.org/10.34133/space.0315

3

Views

1

Downloads

0

Crossref

0

Web of Science

0

Scopus

Received: 09 October 2024
Revised: 21 May 2025
Accepted: 22 June 2025
Published: 26 January 2026
© 2026 Wei Wang et al. Exclusive licensee Beijing Institute of Technology Press. No claim to original U.S. Government Works.

Distributed under a Creative Commons Attribution License (CC BY 4.0).