AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (3.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access

Methods of Measuring Secondary Electron Yield for Space Dielectric Materials

Xueman Wan1, Jing Yang1, Na Zhang1, Yun He1, Tiancu Hu1, Wanzhao Cui1,2( )
National Key Laboratory of Science and Technology on Space Microwave, China Academy of Space Technology (Xi’an), Xi’an 710100, China
School of Electronics and Information, Northwestern Polytechnical University, Xi’an 710072, China
Show Author Information

Abstract

The total secondary electron yield (SEY) of dielectric materials under pulse electron beam was investigated using the collector method. Accurate SEY characterization is essential for assessing surface charging effects in the space environment. However, SEY measurements of dielectrics, particularly easily charged Al2O3, are highly sensitive to both the performance of the measurement facilities and the surface conditions of materials. Two analytical models, dc output method and pulsed output method, were analyzed and compared. The results indicate that the single-pulsed method is more suitable for air-exposed metals and poorly conductive dielectrics, whereas for clean and contamination-free metals, the dc and pulsed yield models provide consistent SEY values. To obtain intrinsic, charging-free SEY data, measurements must be performed under low electron dose conditions with appropriate charge neutralization. Otherwise, the measured SEY exhibits an exponential decay under continuous electron pulses. In addition, excessive neutralization can also reduce the measured SEY below its intrinsic level. Based on the measurement methods, SEY values for several space dielectric materials were obtained. The results demonstrate that SEY is influenced by surface morphology, increasing with surface finishing from rough to ground or polished states. However, mechanical polishing shows little effect on SEY for smooth Al2O3 surfaces with roughness below 0.30 μm. Among the investigated materials, polished Al2O3 exhibits the highest SEY, with a maximum value of 7.72 ± 0.18 at an incident electron energy of 900 eV.

References

【1】
【1】
 
 
Space: Science & Technology
Article number: 0311

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Wan X, Yang J, Zhang N, et al. Methods of Measuring Secondary Electron Yield for Space Dielectric Materials. Space: Science & Technology, 2026, 6: 0311. https://doi.org/10.34133/space.0311

2

Views

0

Downloads

0

Crossref

0

Web of Science

0

Scopus

Received: 08 January 2025
Revised: 27 March 2025
Accepted: 08 May 2025
Published: 26 March 2026
© 2026 Xueman Wan et al. Exclusive licensee Beijing Institute of Technology Press. No claim to original U.S. Government Works.

Distributed under a Creative Commons Attribution License (CC BY 4.0).