AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (11.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access | Just Accepted

Boosting triboelectric nanogenerators via hierarchical textures: insights from coupled adhesion contact and electrical modeling

Weixu Yang1( ), Dengji Gao1, Yanqiang Hu2, Ping Chen1, Zhongkui Wang3

1 Department of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China

2 Beijing Key Laboratory of Long-life Technology of Precise Rotation and Transmission Mechanisms, Beijing Institute of Control Engineering, Beijing 100094, China

3 Beijing Shougang Resource Recycling Technology Co., Ltd., Qian’an 064400, China

Show Author Information

Abstract

Triboelectric nanogenerators (TENGs) are an emerging nanotechnology for distributed energy harvesting, where introducing hierarchical micro/nanotextures onto contact interfaces effectively enhances electrical output. However, existing theoretical models lack the capability to guide the design of hierarchical textures, particularly overlooking the gap-dependent variation of surface charge density, which is a key factor governing the electrical output. Here, a comprehensive numerical model coupling adhesive contact mechanics with electrical performance is established for hierarchical textured TENGs, with the gap-dependent charge density explicitly incorporated.  The effects of texture hierarchy and micro/nano texture sizes are quantitatively analyzed based on numerical algorithms such as bi-conjugate stabilized (Bi-CGSTAB) method and fast Fourier transform (FFT) technique. It is shown that the present model achieves significantly improved agreement with experimental measurements compared with the conventional constant-charge-density assumption. Under a large indentation depth, hierarchical textures yield an open-circuit voltage of up to 295.7 V, representing an enhancement of 7.97% over single-scale textures, while reducing the pull-off force by 84.6% to effectively prevent separation failure and the consequent voltage degradation. At a small indentation depth, hierarchical textures offer an optimal trade-off between high output and low adhesion. Notably, nanotexture size exerts a dominant regulatory influence on output performance, with larger nanotexture sizes significantly boosting the open-circuit voltage, whereas microtexture size shows a weaker effect. These quantitative insights provide theoretical references for texture design and performance optimization of high-output hierarchical textured TENGs.

Graphical Abstract

References

【1】
【1】
 
 
Nano Research

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Yang W, Gao D, Hu Y, et al. Boosting triboelectric nanogenerators via hierarchical textures: insights from coupled adhesion contact and electrical modeling. Nano Research, 2026, https://doi.org/10.26599/NR.2026.94909277
Topics:

185

Views

6

Downloads

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 30 July 2026
Revised: 24 September 2026
Accepted: 22 October 2026
Available online: 22 October 2026

© The Author(s) 2026. Published by Tsinghua University Press.

This is an open access article under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0, https://creativecommons.org/licenses/by/4.0/)