AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (3.6 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Research Report | Open Access | Just Accepted

Influence of CO32- and SO42- on the chloride binding capacity of AAMs with municipal solid waste incineration fly ash

Yu Chen1, Dezhi Zhao1,2, Teng Ma1, Zhengxin Chen1,2, Caihong Xue1,2( ), Qingxin Zhao1,2

1 State Key Laboratory of Metastable Materials Science and Technology, Yanshan University, Qinhuangdao 066000, China

2 Hebei Province Engineering Research Center for Harmless Synergistic Treatment and Recycling of Municipal Solid Waste, Yanshan University, Qinhuangdao 066004, China

Show Author Information

Abstract

Alkali-activated materials (AAMs) are widely used for the treatment of chloride-rich municipal solid waste incineration fly ash (MSWI FA). However, there is a lack of study on the influence of inevitable CO32- and SO42- from MSWI FA on the chloride binding capacity of AAMs. In this study, AAMs with different levels of internal Cl-, SO42- and CO32- were prepared to simulate the systems with MSWI FA to provide insights into the intricate competition of three anions for being bound by in-situ formed hydrotalcites (Ht) in AAMs. The results showed that at 5 wt% internal Cl-, CO32- reduced bound chloride by 0.81~3.4%, whereas SO42- increased it by 3.7~10.2%, and the influence of both anions decreased with prolonging curing time from 7d to 28d. Ht formation in AAMs with 3 wt% Cl- increased from 5.6 wt% to 6.3 wt% and to 7.1 wt% with the presence of CO32- and SO42-, respectively, while an increase in Cl- from 3 wt% to 5 wt% slightly varied the Ht content. Cold-water extraction for chloride binding capacity quantification varied the phase assemblage due to dissolution, and the optimal extraction time was 2h for powder samples. Spatial distribution of Ht was obtained by quantitative SEM-EDS hypermaps analysis, which revealed that Ca-Al Ht and Mg-Al Ht coexisted around GGBS, but Cl- and SO42- showed preference for intercalation into the Ca-Al Ht. The SO42- from dissolved GGBS competed with Cl- for intercalating into Ht, and the statistic distribution of S and Cl in the Ht formed in AAMs was probably independent of the relative concentration of two anions in the raw materials. The findings suggest that stabilizing the sulfate by other phases rather than Ht to reduce the competition with chloride is vital to achieve high chloride binding by Ht in AAMs with MSWI FA.

Graphical Abstract

References

【1】
【1】
 
 
Materials Reports: Solidwaste and Ecomaterials

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Chen Y, Zhao D, Ma T, et al. Influence of CO32- and SO42- on the chloride binding capacity of AAMs with municipal solid waste incineration fly ash. Materials Reports: Solidwaste and Ecomaterials, 2026, https://doi.org/10.26599/MRSE.2026.9520042

62

Views

5

Downloads

0

Crossref

Received: 13 October 2026
Revised: 27 October 2026
Accepted: 12 November 2026
Available online: 16 November 2026

© The Author(s) 2026. Published by Tsinghua University Press.

This is an open access article under the CC BY license (https://creativecommons.org/licenses/by/4.0/).