AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (10.3 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

Effects of methylcellulose on the surface mechanical behavior and wear mitigation mechanism of stainless-steel grippers

JinTao SHI, Xuan YIN( ), Bing ZHANG
College of Mechanical and Electrical Engineering, Beijing University of Chemical Technology, Beijing 100029, China
Show Author Information

Abstract

The surface tribological behavior of stainless-steel gripping claws exerts a decisive influence on their service life. A plane-to-plane friction and wear tester was employed to simulate the surface tribological behavior of the gripping claws during actuation. Methylcellulose (MC) was applied to the contact interfaces of five stainless steel pairs to replicate the operating conditions of the gripping claws, followed by tribological testing and characterization analysis. This study investigated the effect of MC in mitigating wear of different steel materials and revealed its friction-reducing and anti-wear mechanisms. The results demonstrate that wear on the gripping claw surface is primarily concentrated at the claw tip and the front segment of the claw body. Tribological test results indicate that the friction coefficient exhibits a decreasing trend with increasing load; when the load reaches 25 N, the friction coefficient between 321 stainless steel and MC is as low as 0.014. Additionally, the steel material itself has a significant impact on the friction coefficient, with Ti-containing 321 stainless steel demonstrating the optimal friction-reducing performance. The mechanism involves friction-induced effects that facilitate the formation of adsorbed and molten transfer films of MC on the stainless steel surface. These transfer films effectively isolate the direct contact between the upper and lower friction pairs, thereby enhancing lubrication efficiency while significantly attenuating abrasive wear and adhesive wear.

CLC number: TH117; TQ352

References

【1】
【1】
 
 
Journal of Beijing University of Chemical Technology (Natural Science Edition)
Pages 69-79

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SHI J, YIN X, ZHANG B. Effects of methylcellulose on the surface mechanical behavior and wear mitigation mechanism of stainless-steel grippers. Journal of Beijing University of Chemical Technology (Natural Science Edition), 2026, 53(5): 69-79. https://doi.org/10.13543/j.bhxbzr.2026.05.008

1

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 27 November 2025
Published: 20 September 2026
© 2026 The Authors.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).