AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (11.7 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Publishing Language: Chinese | Open Access

Effect of carbon fiber pretreatment temperature on 0° tensile properties of polyether ether ketone thermoplastic prepreg

Jiaxin HOU, Zhiran ZHENG, Dianrui ZHOU, Fenghui SHI, Baoyan ZHANG( )
Composite Technology Center,AVIC Manufacturing Technology Institute,Beijing 101300,China
Show Author Information

Abstract

Several groups of thermoplastic polyether ether ketone (PEEK) prepregs with different process parameters by adjusting the pretreatment temperature of carbon fiber are prepared, and the physicochemical properties, 0-degree tensile properties and microstructure of each group of thermoplastic prepregs are characterized. The results show that the pretreatment temperature of carbon fiber is increased from 300 ℃ to 450 ℃, and the 0° tensile strength of thermoplastic prepreg is increased from 1834.4 MPa to 2258.7 MPa, an increase of more than 20%. Meanwhile, the crystallization state of PEEK induced by heat-treated carbon fiber is observed by polarizing microscopy. Combined with test results of carbon fiber surface element distribution obtained via X-ray photoelectron spectroscopy (XPS), it is found that the heat-treated carbon fiber can significantly improve the tendency of PEEK heterogeneous nucleation, which has an impact on the crystallization process of PEEK.

CLC number: V258 Document code: A Article ID: 1005-5053(2026)11-0086-14

References

【1】
【1】
 
 
Journal of Aeronautical Materials
Pages 86-99

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
HOU J, ZHENG Z, ZHOU D, et al. Effect of carbon fiber pretreatment temperature on 0° tensile properties of polyether ether ketone thermoplastic prepreg. Journal of Aeronautical Materials, 2026, 46(11): 86-99. https://doi.org/10.11868/j.issn.1005-5053.2025.000228

1

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 11 December 2025
Accepted: 25 February 2026
Published: 15 November 2026
© Journal of Aeronautical Materials 2026.

This is an open access article under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).