AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (20.7 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Publishing Language: Chinese | Open Access

CMAS corrosion and wetting behaviour of porous microstructure in thermal barrier coatings

Yangguang LIU1, Weize WANG1,2( ), Wenkang ZHANG1, Shandong TU1,2
Key Laboratory of Pressure System and Safety,Ministry of Education,East China University of Science and Technology,Shanghai 200237,China
Shanghai Institute of Aircraft Mechanics and Control,Shanghai 200237,China
Show Author Information

Abstract

The work aims to investigate the CMAS(calcia-magnesia-aluminosilicate) corrosion behavior of plasma co-sprayed YSZ(yttria-stabilized zirconia) coatings obtained at different gun speeds. The thermal barrier coatings prepared by plasma co-spraying at different gun traverse speeds are subjected to CMAS corrosion at high-temperature. The penetration of CMAS in the coating is studied by scanning electron microscopy and energy dispersive X-ray spectroscopy. The wetting behavior of CMAS on the coating is investigated using the seat drop method, and the effects of roughness on the corrosion and wetting of CMAS are studied. Results show that the coatings prepared at a gun speed of 600 mm/s does not exhibit delamination after CMAS corrosion at 1300 ℃/1 h, and has the best resistance to CMAS corrosion penetration. In CMAS wetting experiments, coatings prepared at a gun speed of 100 mm/s have significant advantages in resisting CMAS wetting behavior. The roughness Ra of the coating ranges from 3.47 μm to 3.77 μm, with little difference, which eliminates the influence of roughness on wetting behavior. The CMAS tiling barrier on the embedded particle formation structure on the coating surface is the reason for the poor wetting performance at the low gun speed in this experiment. The difference in the structure of embedded particles on the surface and inside of the coating is the main factor that results in good CMAS penetration resistance at high gun speed.

CLC number: V254.2;TG174.442 Document code: A Article ID: 1005-5053(2026)11-0100-10

References

【1】
【1】
 
 
Journal of Aeronautical Materials
Pages 100-109

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LIU Y, WANG W, ZHANG W, et al. CMAS corrosion and wetting behaviour of porous microstructure in thermal barrier coatings. Journal of Aeronautical Materials, 2026, 46(11): 100-109. https://doi.org/10.11868/j.issn.1005-5053.2025.000040

2

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 12 March 2025
Accepted: 30 April 2025
Published: 15 November 2026
© Journal of Aeronautical Materials 2026.

This is an open access article under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).