AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (6.2 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Paper | Open Access

7-axis synchronization-integrated on-the-fly laser texturing system of freeform surface: design and development

Wenqi Ma1, Jinmiao Zhang1, Liang Zhao2 , Zhenjiang Hu1, Xuesen Zhao1, Tao Sun1, Junjie Zhang1 ( )
Center for Precision Engineering, Harbin Institute of Technology, Harbin 150001, People’s Republic of China
Shenyang Aircraft Industry (Group) Co., Ltd, Shenyang 110850, People’s Republic of China
Show Author Information

Abstract

While laser surface texturing (LST) is a promising manufacturing technique for surface functionalization, simultaneously realizing high precision and high efficiency in the LST of complex curved surface is challenging, due to continuously varied geometries of laser-matter incidence. In the present work, we propose a novel manufacturing system of 7-axis on-the-fly LST for complex curved surface, based on the integrated synchronization of 5-axis linkage motion platform with 2-axis galvanometer. Specifically, the algorithm for decomposing spatial texture trajectory on curved surface into low-frequency and high-frequency parts is established, based on which the kinematic model of synchronized 7-axis system is developed to derive the motion of each axis in both 5-axis linkage motion platform and 2-axis galvanometer simultaneously. Subsequently, the synchronized 7-axis LST system is experimentally realized, including the setup of mechanical stages integrated with optical path, the configuration of numerical control unit, and the development of processing software. Finally, case study of 7-axis on-the-fly LST of freeform aluminum surface is performed, and the advantages in terms of processing efficiency and texturing accuracy over 5-axis linkage LST are demonstrated. The correlation of reduced following errors between mechanical stages with the promoted performance of curved surface texturing by the 7-axis on-the-fly LST is further analyzed. Current work provides a feasible solution for establishing the manufacturing system for high performance LST of complex curved surface.

References

【1】
【1】
 
 
International Journal of Extreme Manufacturing

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Ma W, Zhang J, Zhao L, et al. 7-axis synchronization-integrated on-the-fly laser texturing system of freeform surface: design and development. International Journal of Extreme Manufacturing, 2025, 7(1). https://doi.org/10.1088/2631-7990/ad8aa8

884

Views

22

Downloads

26

Crossref

35

Web of Science

34

Scopus

0

CSCD

Received: 08 April 2024
Revised: 23 May 2024
Accepted: 22 October 2024
Published: 07 November 2024
© 2024 The Author(s).

Original content from this work may be used under the terms of the Creative Commons Attribution 4.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.