AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (4.2 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Paper | Open Access

The interaction between grain boundary and tool geometry in nanocutting of a bi-crystal copper

Zhanfeng Wang1, Tao Sun1( ), Haijun Zhang2, Guo Li2, Zengqiang Li1, Junjie Zhang1 ( ), Yongda Yan1, Alexander Hartmaier1,3
Center for Precision Engineering, Harbin Institute of Technology, Harbin 150001, People’s Republic of China
Research Center of Laser Fusion, China Academy of Engineering Physics, Mianyang 621900, People’s Republic of China
Interdisciplinary Centre for Advanced Materials Simulation, Ruhr-University Bochum, Bochum, 44780, Germany
Show Author Information

Abstract

Anisotropy is one central influencing factor on achievable ultimate machined surface integrity of metallic materials. Specifically, grain boundary has a strong impact on the deformation behaviour of polycrystalline materials and correlated material removal at the microscale. In the present work, we perform molecular dynamics simulations and experiments to elucidate the underlying grain boundary-associated mechanisms and their correlations with machining results of a bi-crystal Cu under nanocutting using a Berkovich tool. Specifically, crystallographic orientations of simulated bi-crystal Cu with a misorientation angle of 44.1° are derived from electron backscatter diffraction characterization of utilized polycrystalline copper specimen. Simulation results reveal that blocking of dislocation motion at grain boundaries, absorption of dislocations by grain boundaries and dislocation nucleation from grain boundaries are operating deformation modes in nanocutting of the bi-crystal Cu. Furthermore, heterogeneous grain boundary-associated mechanisms in neighbouring grains lead to strong anisotropic machining behaviour in the vicinity of the grain boundary. Simulated machined surface morphology and machining force evolution in the vicinity of grain boundary qualitatively agree well with experimental results. It is also found that the geometry of Berkovich tool has a strong impact on grain boundary-associated mechanisms and resultant ploughing-induced surface pile-up phenomenon.

References

【1】
【1】
 
 
International Journal of Extreme Manufacturing
Pages 045001-045001

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Wang Z, Sun T, Zhang H, et al. The interaction between grain boundary and tool geometry in nanocutting of a bi-crystal copper. International Journal of Extreme Manufacturing, 2019, 1(4): 045001. https://doi.org/10.1088/2631-7990/ab4b68

968

Views

79

Downloads

30

Crossref

N/A

Web of Science

39

Scopus

0

CSCD

Received: 11 August 2019
Revised: 23 September 2019
Accepted: 07 October 2019
Published: 28 October 2019
© 2019 The Author(s).

Original content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.